Nortel Networks 400-S manual Nortel Networks NA Inc. software license agreement

Page 8

8

bouclé peut être constítuée de n'importe quelle combinaison de dispositifs, pourvu que la somme des indices de charge de l'ensemble des dispositifs ne dépasse pas 100.

L'indice de charge se trouve sur le modem.

Nortel Networks NA Inc. software license agreement

NOTICE: Please carefully read this license agreement before copying or using the accompanying software or installing the hardware unit with pre-enabled software (each of which is referred to as “Software” in this Agreement). BY COPYING OR USING THE SOFTWARE, YOU ACCEPT ALL OF THE TERMS AND CONDITIONS OF THIS LICENSE AGREEMENT. THE TERMS EXPRESSED IN THIS AGREEMENT ARE THE ONLY TERMS UNDER WHICH NORTEL NETWORKS WILL PERMIT YOU TO USE THE SOFTWARE. If you do not accept these terms and conditions, return the product, unused and in the original shipping container, within 30 days of purchase to obtain a credit for the full purchase price.

1.License grant. Nortel Networks NA Inc. (“Nortel Networks”) grants the end user of the Software (“Licensee”) a personal, nonexclusive, nontransferable license: a) to use the Software either on a single computer or, if applicable, on a single authorized device identified by host ID, for which it was originally acquired; b) to copy the Software solely for backup purposes in support of authorized use of the Software; and c) to use and copy the associated user manual solely in support of authorized use of the Software by Licensee. This license applies to the Software only and does not extend to Nortel Networks Agent software or other Nortel Networks software products. Nortel Networks Agent software or other Nortel Networks software products are licensed for use under the terms of the applicable Nortel Networks NA Inc. Software License Agreement that accompanies such software and upon payment by the end user of the applicable license fees for such software.

2.Restrictions on use; reservation of rights. The Software and user manuals are protected under copyright laws. Nortel Networks and/or its licensors retain all title and ownership in both the Software and user manuals, including any revisions made by Nortel Networks or its licensors. The copyright notice must be reproduced and included with any copy of any portion of the Software or user manuals. Licensee may not modify, translate, decompile, disassemble, use for any competitive analysis, reverse engineer, distribute, or create derivative works from the Software or user manuals or any copy, in whole or in part. Except as expressly provided in this Agreement, Licensee may not copy or transfer the Software or user manuals, in whole or in part. The Software and user manuals embody Nortel Networks’ and its licensors’ confidential and proprietary intellectual property. Licensee shall not sublicense, assign, or otherwise disclose to any third party the Software, or any information about the operation, design, performance, or implementation of the Software and user manuals that is confidential to Nortel Networks and its licensors; however, Licensee may grant permission to its consultants, subcontractors, and agents to use the Software at Licensee’s facility, provided they have agreed to use the Software only in accordance with the terms of this license.

3.Limited warranty. Nortel Networks warrants each item of Software, as delivered by Nortel Networks and properly installed and operated on Nortel Networks hardware or other equipment it is originally licensed for, to function substantially as described in its accompanying user manual during its warranty period, which begins on the date Software is first shipped to Licensee. If any item of Software fails to so function during its warranty period, as the sole remedy Nortel Networks will at its discretion provide a suitable fix, patch, or workaround for the problem that may be included in a future Software release. Nortel Networks further warrants to Licensee that the media on which the Software is provided will be free from defects in materials and workmanship under normal use for a period of 90 days from the date Software is first shipped to Licensee. Nortel Networks will replace defective media at no charge if it is returned to Nortel Networks during the warranty period along with proof of the date of shipment. This warranty does not apply if the media has been damaged as a result of accident, misuse, or abuse. The Licensee assumes all responsibility for selection of the Software to achieve Licensee’s intended results and for the installation, use, and results obtained from the Software. Nortel Networks does not warrant a) that the functions contained in the software will meet the Licensee’s requirements, b) that the Software will operate in the hardware or software combinations that the Licensee may select, c) that the operation of the Software will be uninterrupted or error free, or d) that all defects in the operation of the Software will be corrected. Nortel Networks is not obligated to remedy any Software defect that cannot be reproduced with the latest Software release. These warranties do not apply to the Software if it has been (i) altered, except by Nortel Networks or in accordance with its instructions; (ii) used in conjunction with another vendor’s product,

209375-A

Image 8
Contents Setting Up the BayStack Instant Internet 400-S Unit USA requirements only Japan/Nippon requirements only Modular components used in this assembly Setting Up the BayStack Instant Internet 400-S Unit UL listing/C-UL listing NT1 Instant Internet Isdn Device Nortel Networks NA Inc. software license agreement Setting Up the BayStack Instant Internet 400-S Unit 209375-A Contents Chapter Seven-port autosensing switch specifications Appendix a Technical specifications Contents 209375-A Figures Figures 209375-A Tables Tables 209375-A Preface Before you beginAcronyms Following acronyms are used in this manualRelated publications Preface How to get help Preface 209375-A Chapter Introduction Instant Internet packageAvailable options Requirements and compatibility Introduction 209375-A Chapter Installation preparation Preparing for Internet accessSelecting an Internet service provider Making decisionsInstallation checklist Installation checklistInstallation preparation Installation checklist Installation worksheet ISP InformationIs Isdn Dial backup available if requested Chapter Instant Internet 400-S hardware installation Getting to know your Instant Internet 400-S unitDIP switches see , DIP switch settings, on Interfaces Rear panel of the Instant Internet 400-S unitEthernet interfaces Power cords Isdn S/TLists specifications for international power cords Achtung Bitte sofort lesen Setting the voltage selector switch Attenzione Leggere attentamenteInstant Internet quick installation Instant Internet 400-S hardware installation Instant Internet 400-S hardware installation Mounting your Instant Internet unit in a rack Removing screws from cover of Instant Internet 400-S unit 9863FB 10045FA Instant Internet 400-S hardware installation 209375-A Chapter Seven-port autosensing switch specifications Instant Internet 10/100 Ethernet switch overviewSwitch features RJ-45 10BASE-T/100BASE-TX Ethernet portsMDI/MDI-X autosensing capability LEDsSeven-port autosensing switch specifications 209375-A Chapter DIP switch settings DIP switchesSwitch settings for normal operation Switch settings for special configurationsDIP switch settings Resetting your Instant Internet unit Refer to Switch settings for special configurations onDIP switch settings DIP switch settings 209375-A Chapter LEDs support and diagnostic functions Interpreting Instant Internet LEDsLEDs 1 through 8 and Power LED at power-up sequence LEDs support and diagnostic functionsLEDs 1 through 8 and the Power LED during operation LED status and appearance during operationSeven-port switch port status LEDs Chapter Out-of-band management support Connecting a PC to the Instant Internet unit Configuring a direct connectionHyperTerminal Connection Description dialog box HyperTerminal Connect To dialog box Command prompt Connecting a modem to a PC Configuring modem connection settingsHyperTerminal Connection Description dialog box Ats0=1&w\r Connecting to an Instant Internet unit Connecting a modem to the Instant Internet unitOut-of-band management support 209375-A Electrical specifications Appendix a Technical specificationsPhysical specifications Environmental specifications Cable part numbers Appendix B Adapter cable pinout diagramsDirect access adapter cables 35 adapter cable pinout diagram Adapter cable21 DCE adapter cable diagram DCE adapter cableRemote access adapter cables Null modem adapter PC-to-PC cableModem adapter cable pinout diagram Modem adapter cableAppendix B Adapter cable pinout diagrams 209375-A Symbols NumbersIndex Index Index