36Ethernet Routing Switch 8310 and 8306 chassis installation
Prerequisites
•Provide adequate space around the unit for access to cable connectors.
•Ensure that the surface can safely support the weight of the chassis, its components, and its attached cables. See “Chassis installation time requirements” (page 35).
Procedure steps
Step Action
1Set the switch on the flat surface and check for proper ventilation.
Allow at least 2 inches 5.1 cm) on each side for proper ventilation and 5 inches (12.7 cm) at the front for power cord clearance.
2Attach rubber feet to each marked location on the bottom of the chassis.
The rubber feet are optional but recommended to keep the unit from slipping.
3Attach all devices to the ports.
Procedure job aid: Chassis weight including components
The following table shows the weight of each chassis including the components.
Chassis | Maximum weight (chassis and components) |
|
|
8310 | 225 pounds (lb) (102 kilograms [kg]) |
|
|
8306 | 140 lb (63 kg) |
|
|
Mounting the Ethernet Routing Switch 8310 and 8306 chassis in an equipment rack
Install the Ethernet Routing Switch 8310 and 8306 chassis in a standard
ATTENTION
If you are mounting the chassis in a
Nortel Ethernet Routing Switch 8300
Installation — Chassis
16 June 2008
Copyright © 2008 Nortel Networks