
22Installing Device Manager software
If several warning messages are displayed after you launch Device Manager on a Solaris workstation, do the following:
•Add the following statement to your .cshrc file: setenv XKEYSYMDB $HOME/ .XKeysymDB
•Make sure there is a .XKeysymbDB file in your home directory.
Executing the Device Manager installation software on UNIX
Use this procedure to execute the Device Manager installation software in a UNIX environment.
Procedure steps
Step Action
1Close all programs.
2Navigate to the directory on your system where you loaded the Device Manager software.
3For the Linux environment, make the file executable by entering: chmod a+x jdm_ xxxx_linux.sh
For the Solaris environment, make the file executable by entering: chmod a+x dm_xxxx_solaris_sparc.bin
4For the Linux environment, run the jdm_xxxx_linux.sh file.
For the Solaris environment, run the dm_xxxx_so- laris_sparc.bin file.
An installation screen, followed by a Nortel dialog box opens. Then, the Introduction dialog box appears (see "InstallAnywhere Introduction dialog box" (page 23)).
Nortel Metro Ethernet Routing Switch 8600
Fundamentals — Using Device Manager
4.21 October 2007
Copyright ©