ªState of Power Lamp while
charging
The Power Lamp flashes while charging. (Flashes approx. every 2 seconds when charging is normal.)
When the Power Lamps flashes more quickly or slowly (or turns off), some abnormality may have occurred.
The flashing speed suggests the following states.
Flashing approx. every 0.5 seconds:
≥The SD Multi AV Device, battery or AC adaptor may be defective. Contact your nearest Panasonic dealer.
Flashing approx. every 6 seconds:
≥The ambient temperature or that of the battery itself is too high or too low. Charging proceeds, but will take a longer time.
Turning off:
Charging is completed.
If the Power Lamp turns off when charging is not completed, the AC Adaptor or the battery is probably defective. Contact your nearest Panasonic dealer.
Notes and Hints
ªPower Supply (l 10)
≥When the Battery Level Indicator
indicates [ 
], the battery will run out in a few minutes. Recharge the battery.
≥It takes approx. 120 minutes, maximum for
≥The capacities of the recording time/ playback time/still picture storage with a supplied,
Number of Recordable Still Pictures | 1200 |
(PICTURE) |
|
Maximum Continuous Recording Time | 90 min. |
(MPEG4) |
|
Maximum Continuous Voice | 180 min. |
Recording Time (VOICE) |
|
Maximum Continuous Music Playback | 180 min. |
Time (MUSIC) |
|
(When the [POWER SAVE] function is |
|
activated) |
|
|
|
The times/number of images listed in the above table are approximate.
≥If you disconnect the DC Input Lead or the AC Main Lead while charging the Battery, Power Lamp flashes several times and goes off. For continuing Battery charge, wait for approx. 1 minute, and then connect the AC Main Lead and the DC Input Lead.
≥It is recommended to set the battery even when using the AC adaptor.
≥The main unit becomes hot when it is being charged or used. This is normal.
≥When removing the battery, take care not to drop it.
≥When the SD Multi AV Device is turned on, do not attach or remove the battery, or plug the power cord in or out.
ªInserting a Memory Card (l 11)
≥While the Card Access Lamp is on, the following operations should not be attempted: (Such action will damage the Memory Card, cause loss of recorded data and cause the SD Multi AV Device to malfunction.)
≥An SD Memory Card can be used for this SD Multi AV Device.
≥Do not touch the terminals on the back of
the Memory Card with your fingers. | 55 |