Rockford Fosgate 160X4, 240X4 operation manual Punch

Page 15

3.Punch 160x4

Trim the power cable to within 18" of the battery and install the protective rubber boot packed with the fuseholder over the end of the wire. Strip 3/8" of insulation from the wire and insert it into the end of the fuseholder, then crimp it in place. Slide the rubber boot into place to cover the connection. Use the section of cable trimmed earlier and connect it to the other end of the fuseholder.

Punch 240x4

Mount the fuseholder within 18" of the battery using two (2) #8 screws. Disassemble the fuseholder. You should have 2 black plastic end caps, 2 gold-plated fuse clips, a plastic spacer and the fuseholder body. Trim the amplifier power cable to reach the fuseholder and strip the wire 3/8". Slide one of the end caps over the wire (narrow end first) and insert the wire into one of the fuse clips. Tighten the set screw. Screw the black end cap to the fuseholder body to secure the cable. Use the section of cable that was trimmed earlier and connect it to the other end of the fuseholder. Install the plastic spacer in the fuseholder and attach the cable to the fuseholder body.

NOTE: The B+ cable MUST be fused 18" or less from the vehicle's battery. Install the fuseholder under the hood and prepare the cable ends as stated above. Connections should be water tight.

4.Strip 3/8" from the battery end of the power cable and crimp the large ring terminal to the cable. Use the ring terminal to connect to the battery positive terminal. Do not install the fuse at this time.

5.Prepare a length of cable to be used for the ground connection. Strip 5/8" of insulation from the end of the cable as described previously and connect to the appropriate terminal of the amplifier. Prepare the chassis ground by scraping any paint from the metal surface and thoroughly clean the area of all dirt and grease. Strip the other end of the wire and attach a ring connector. Fasten the cable to the chassis using a screw.

– 11 –

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Channel Amplifiers Installation & Operation Manual Page Practice Safe Sound T T I N G S T a R T E D PU N C H 4-CHANNEL AM P L I F I E R AC C E S S O R Y PA C K T R O D U C T I O NRO C K F O R D FO S G AT E AC C E S S O R I E S Energy Storage CapacitorTransana TRANSconductance Active Nodal Amplifier Technical Design FeaturesXCard Internal Crossover Mosfet Devices Design Features Amplifier S TA L L AT I O N CO N S I D E R AT I O N S Mounting Location R I N G T H E S Y S T E M Battery and ChargingPunch Page I N G T H E Xcard Channel Input Using the Signal Input SwitchBA S I C CO N N E C T I O N S Power ConnectionsStereo Operation Mono Operation P U T Channel OperationChannel Stereo Operation Channel Stereo/Single Bridged Operation Channel Stereo/Dual Bridged Operation Watt 3-Way System SY S T E M DI a G R a M SWatt 4-Way System 12dB/octaveLP Watt 4-Way System Amplifier has no TroubleshootingAmplifier does not Turn onRear Channels Speaker OutputLow or Distorted No Output onEngine Noise Listening to Loudspeakers Not Resistors About the Dynamic Power MeasurementsN a M I C P O W E R M E a S U R E M E N T S MusicInformation Cubed What is an Amplifier?120 160X4 Specification S100 180R R a N T Y I N F O R M a T I O N Page Page Rockford Fosgate
Top Page Image Contents