Panasonic CQ-DF302W Error Display Messages, Sound Setting, Remote Control, CD Changer

E N G L I

Troubleshooting (Continued)

E N G L I

S

H

19

❐CD

Trouble

Disc is in the CD compart- ment but no sound is made, or disc is ejected automatically.

Sound skips, bad sound quality (e.g. caused by noise)

Sound skips due to vibra- tion.

Disc is not ejected.

Time is counted but no sound comes out.

❐Sound Setting

No sound from left, right, front or rear speakers.

Left and right sounds are reversed in stereo listen- ing.

Cause/Step

Disc is upside down.

➡Place disc in the correct direction, and the label side up.

≥Disc is dirty.

≥Disc has scratches.

➡Clean disc, referring to the section on “Notes on CD/CD media (CD-R, CD-RW)”.

A disc that has data other than CD-DA type is loaded.

➡Discs that have CD-DA type data should be used.

➡The unit may not successfully play back a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details.

≥Disc is dirty.

≥Disc has scratches.

➡Clean disc, referring to the section on “Notes on CD/CD media (CD-R, CD-RW)”.

➡The unit may not successfully play back a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details.

Mounting angle is over 30o.

➡Adjust mounting angle to less than 30o.

Instable mounting.

➡Mount the unit securely with the mounting parts, referring to the section on installation.

≥Disc is defective.

≥Mechanical trouble.

➡Press [OPEN] to open the panel and press [<] (EJECT). If normal operation is not restored yet, call the store where you purchased the unit or the near- est Servicenter to ask for repairs.

The first track of a mix mode disc was reproduced. (Mix mode is a format in which data except music is recorded on the first track and music data is recorded on other than the first track in a session.)

➡Play back music data recorded on other than the first track.

Left and right balance, or front and rear balance is off on one side.

➡Adjust balance/fader mode as appropriate.

Cables are not correctly connected.

➡Connect the cables correctly.

The right speaker wire is connected to the left speaker and the left speaker wire to the right speaker.

➡Connect the speaker wires to the correct ones.

❐Remote Control

Trouble Cause/Step

Battery poles (i) (j) are reversed.

➡Insert the battery correctly.

Wrong the battery.

➡Check the battery.

Buttons are	invalid for
operation.	Battery has run down.

➡Replace the battery.

Remote control is in the wrong direction.

➡Direct the remote control at sensor (REMOTE) on the panel.

Error Display Messages

❐CD

Display Cause/Step

≥Disc is dirty, or is upside down.

≥A disc that has data other than CD-DA type is loaded.

➡Press [OPEN] to open the front panel, and then press [<] (EJECT) to eject the disc.

Disc has scars.

➡Press [OPEN] to open the front panel, and then press [<] (EJECT) to eject the disc.

No operation by some cause.

➡Turn off the car engine (ACC off) and remove the fuse from the battery lead (yellow) for 1 minute. Then reinstall the fuse.

❐CD Changer

≥Disc is dirty, or is upside down.

≥ A disc other than a music CD (CD-DA type) is loaded.

DISC No.➡Select the next available compact disc.

Disc has scratches.

➡Select the next available compact disc.

DISC No.

No operation by some cause.

➡Press [RESET] on the CD changer (optional).

No disc in the changer (magazine).

➡Insert discs into the changer (magazine).

Notes:

≥There may be cases where the disc numbers affected by an error are displayed before “E1” or “E2”.

≥Displays and the steps to be taken for errors vary in part from changer to changer. For details, refer to the operating instructions for the changer used.

S

H

20

28 29

CQ-DF302W CQ-DF302W