When machine is received, open carton carefully and remove machine by placing hands under machine base for lifting. Place machine on flat surface for installation of label roll holder to machine. (NOTE: Acorn nuts and hex nuts to be removed). Slide label reel over the two threaded studs, secure with hex nuts, then install the two acorn nuts. Machine is not ready for installation and can be secured to an appropriately fabricated bars, flatplate, etc., by the four (4) bolts on the bottom of machine that are securing the bottom cover for shipment.
FOR THOSE MACHINES EQUIPPED WITH LOW LEVEL ALARM AND/OR WEB
BREAK ALARM:
NOTE: Low level alarm is mounted to label reel bar and needs only to be plugged into small 2 prong plug dangling from rear of machine. Swinging curved bar is to be moved downward for loading of labels and rests on outside of roll when in operation, under slight spring pressure. When position of curved bar reaches a position near core of label roll, an audible sound will emit from small box mounted to top of machine. Light will also come on at same time. Both audible alarm and light may be cut off by toggle switch on top of box.
NOTE: Web break alarm - - located between the pull roll and web rewind. Waste web must pass under plastic finger. The finger is supported by waste web and in the event of web breakage, finger will drop downward causing audible signal and light to come on top of box on top of machine.
SEE WIRING DIAGRAM IN BACK OF MANUAL