Printronix T5000e setup guide Hor Image Shift, Orientation

Page 29

QUICK SETUP Submenus

Hor Image Shift

Specifies the amount to shift an image left (-) or right (+) for precise positioning on the label. The actual width of the image is not affected by this parameter. The allowable range is -1.00 through +1.00 inches in .01 inch increments, displayed as xx/100.

The factory default value is 0.00 inches.

Orientation

Specifies the image orientation to be used when printing the label.

•Portrait. The factory default. Portrait refers to vertical page orientation, where the height of a page is greater than its width. The top edge of the image is parallel to the leading edge of the media. The following example is viewed from the front of the printer.

4”

FEED

.media the of edge leading the to parallel is image the of edge top The

6”

Leading Edge

29

Image 29

Contents Quick Setup Guide Page 174951-001E Page Table of Contents Table of Contents Unpacking The Printer Unpacking And Installing The PrinterRemoving The Internal Packing Material Power Switch Controls And IndicatorsInstallation Offline Control PanelControl Panel Control Panel Keys Down Key in Menu mode Menu Key Loading Roll Media Loading Media And RibbonLoading Roll Media Media Ribbon Loading Instructions Loading Roll Media Media left edge Platen left edge Loading Ribbon Media Cover Ribbon Loading Instructions Take-up Core Spindle Printhead Pressure Block Adjustments Printhead Pressure AdjustmentPositioning The Media Sensors Running Auto CalibratePositioning The Media Sensors Saving The ConfigurationRun a Barcode Demo Test Quick Setup Configuration Menu Print Mode Quick Setup SubmenusPrint Intensity Print SpeedPaper Feed Shift Media HandlingVer Image Shift Label LengthLabel Width Orientation Hor Image ShiftTop edge Image is Parallel to Trailing edge Media Gap/Mark Sensor Validator Funct Auto CalibrateFor More Information Save ConfigPower-Up Config For More Information Page 174951-001

Related manuals

Manual 76 pages 43.78 Kb