Printronix T5000e setup guide Loading Roll Media

Page 15

Loading Roll Media

Media Roll

Media Hanger

Guide

4.Slide the media roll onto and towards the back of the media hanger.

5.Place the media hanger guide under the media hanger and against the lower part of the label core at a 45 degree angle (as shown). This position provides the required tension for a new label roll and the desired drag for a partial label roll.

Image 15

Contents Quick Setup Guide Page 174951-001E Page Table of Contents Table of Contents Unpacking The Printer Unpacking And Installing The PrinterRemoving The Internal Packing Material Controls And Indicators InstallationPower Switch Offline Control PanelControl Panel Control Panel Keys Down Key in Menu mode Menu Key Loading Roll Media Loading Media And RibbonLoading Roll Media Media Ribbon Loading Instructions Loading Roll Media Media left edge Platen left edge Loading Ribbon Media Cover Ribbon Loading Instructions Take-up Core Spindle Printhead Pressure Block Adjustments Printhead Pressure AdjustmentPositioning The Media Sensors Running Auto CalibratePositioning The Media Sensors Saving The ConfigurationRun a Barcode Demo Test Quick Setup Configuration Menu Print Speed Quick Setup SubmenusPrint Mode Print IntensityPaper Feed Shift Media HandlingLabel Length Label WidthVer Image Shift Orientation Hor Image ShiftTop edge Image is Parallel to Trailing edge Media Gap/Mark Sensor Validator Funct Auto CalibrateSave Config Power-Up ConfigFor More Information For More Information Page 174951-001

Related manuals

Manual 76 pages 43.78 Kb