Printronix T5000e setup guide Gap/Mark Sensor

Page 31

QUICK SETUP Submenus

FEED

•Inv. Landscape. Inverse Landscape refers to horizontal orientation, where the width of a page is greater than its height. The top edge of the image is parallel to the right edge of the media. The following example is viewed from the front of the printer.

4”

edgeof parallelto theimage Thetop the the is edge 6” media right of .

Leading Edge

Gap/Mark Sensor

Specifies the sensor type needed for detecting the top-of-form position on media with label length indicators (gaps, notches, holes, or black marks).

•Disable. Select when using media with no label length indicators (no gaps, notches, holes, or black marks), or when you want the printer to ignore all existing label length indicators on the installed media.

NOTE: When you select Disable, the length of each label is based on the Label Length value entered.

• Mark. Select when using media that has horizontal black marks located on the underside of the label liner or tag stock. The top-of-form position is the leading edge of the black mark.

• Gap. Select when using media with a liner space between die-cut labels or when using tag stock with notches or holes as label length indicators on white background media. The top-of-form position is the leading edge of the die cut label (trailing edge of the gap, notch, or hole).

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Quick Setup Guide Page 174951-001E Page Table of Contents Table of Contents Unpacking The Printer Unpacking And Installing The PrinterRemoving The Internal Packing Material Installation Controls And IndicatorsPower Switch Offline Control PanelControl Panel Control Panel Keys Down Key in Menu mode Menu Key Loading Roll Media Loading Media And RibbonLoading Roll Media Media Ribbon Loading Instructions Loading Roll Media Media left edge Platen left edge Loading Ribbon Media Cover Ribbon Loading Instructions Take-up Core Spindle Printhead Pressure Block Adjustments Printhead Pressure AdjustmentPositioning The Media Sensors Running Auto CalibratePositioning The Media Sensors Saving The ConfigurationRun a Barcode Demo Test Quick Setup Configuration Menu Print Speed Quick Setup SubmenusPrint Mode Print IntensityPaper Feed Shift Media HandlingLabel Width Label LengthVer Image Shift Orientation Hor Image ShiftTop edge Image is Parallel to Trailing edge Media Gap/Mark Sensor Validator Funct Auto CalibratePower-Up Config Save ConfigFor More Information For More Information Page 174951-001
Related manuals
Manual 76 pages 43.78 Kb
Top Page Image Contents