Printronix T5000e setup guide For More Information, Save Config, Power-Up Config

Page 33

QUICK SETUP Submenus

•Disable.The printer will not command the validator to begin scanning and no errors will be reported. The counters will not be incremented while the validator is disabled.

NOTE: If you save a configuration with the validator enabled, power down and power up, and the validator is not connected or not functioning, the error message “Validator not communicating” will display briefly. The Validator menu will not display.

If the validator is installed, the default is Enable.

Save Config.

Allows you to save up to eight unique configurations to meet different print job requirements. This eliminates the need to change the parameter settings for each new job. The configurations are stored in memory and will not be lost if you turn off the printer. The factory default is 1.

Power-Up Config.

You can specify one the eight configurations as the power-up configuration. The factory default is Factory.

For More Information

This Quick Setup Guide has provided general information for use of your printer. Please refer to your User’s Manual for more detailed information including:

•Other Configuration Menus

•Interfaces

•Diagnostics and Troubleshooting

•Printer Options

•Specifications

•Media Cutter Installation Instructions

•Glossary of Terms

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Quick Setup Guide Page 174951-001E Page Table of Contents Table of Contents Unpacking The Printer Unpacking And Installing The PrinterRemoving The Internal Packing Material Controls And Indicators InstallationPower Switch Offline Control PanelControl Panel Control Panel Keys Down Key in Menu mode Menu Key Loading Roll Media Loading Media And RibbonLoading Roll Media Media Ribbon Loading Instructions Loading Roll Media Media left edge Platen left edge Loading Ribbon Media Cover Ribbon Loading Instructions Take-up Core Spindle Printhead Pressure Block Adjustments Printhead Pressure AdjustmentPositioning The Media Sensors Running Auto CalibratePositioning The Media Sensors Saving The ConfigurationRun a Barcode Demo Test Quick Setup Configuration Menu Print Mode Quick Setup SubmenusPrint Intensity Print SpeedPaper Feed Shift Media HandlingLabel Length Label WidthVer Image Shift Orientation Hor Image ShiftTop edge Image is Parallel to Trailing edge Media Gap/Mark Sensor Validator Funct Auto CalibrateSave Config Power-Up ConfigFor More Information For More Information Page 174951-001
Related manuals
Manual 76 pages 43.78 Kb
Top Page Image Contents