Dymo Rhino Label Maker - Advanced Serialization and Printing Options

To use advanced serialization

1. Enter the text for your label.

2. Press S HIF T + .

3.Select Advanced and press .

A box appears around the character where the cursor was positioned.

4.Select the first character position you want to

increment and press .

5.Select the amount you want to increment this

character position and press .

You can choose to increment in steps up to 10.

6.Select the number of times to increment this

character position and press .

7.Repeat Steps 4 through 6 for the second character position you want to increment.

You can choose to create up to 99 labels.

A new label is added in the display for each label in the series.

Printing Options

You can choose to print multiple copies of the same label, collate the copies, pause to cut between labels, advance the label, and adjust the print contrast.

Printing Multiple Copies

You can print up to 99 copies of the same label at one time.

To print multiple copies
1.	Press S HIF T +	.
2.	Press the S arrow to increase the number of
	copies to print (maximum is 99). The default is
	2 copies.
3.	Press the T arrow to decrease the number
	of copies.
4.	Press	or	to begin printing.

You may notice a brief pause in printing between each label for more complex formats.

When printing is finished, the number of copies to print returns to 2.

Collating Multiple Copies

When printing multiple copies of a label file containing more than one label, all the copies of a label are printed before the next label starts printing. You can choose to have the label file print collated, so each complete copy of the file prints before the second copy starts. The following example shows three copies of a label file containing three labels printed normally and collated.

Normal

A101 A101 A101 A102 A102 A102 A103 A103 A103

Collated

A101 A102 A103 A101 A102 A103 A101 A102 A103

To collate multiple copies

1.Press .

2.Select Collate copies and press .

3.Select On.

4.Press and then select Done (OK).

Pausing Between Labels

By default the printer pauses after printing each label so you can cut the label. You can turn this feature off to have the labels print continuously.

To set the printer to print continuously

1.Press .

2.Select Pause to cut btw labels and

press .

3.Select Off.

4.Press and then select Done (OK).

Advancing the Label

The default leader space for all labels is approximately 5/16” (10 mm). To add additional blank space to the beginning or end of your label, you can feed the label in 5/16” (10 mm) increments.

To advance the label

1. Press S HIF T + .

2. Press to advance the label.

17