Nortel Networks NN43001-318 manual Procedure Perform a Call Join test on Conference

94Testing ISDN BRI functions

9After the second call is established, press the Conference key again to bridge the two calls. All three parties should be in a conference.

10Press the RELEASE key to drop from the call. The ISDN BRI user should be disconnected from the Conference; the remaining two parties should still be connected, for two outgoing trunk calls, in which case all parties should be disconnected.

—End—

Procedure 32

Perform a Call Join test on Conference

Step Action

1In the DSL configuration in LD 27, set PRID = 6 to select the National ISDN-1 protocol, or PRID = 2 for ETSI protocol.

2In the TSP configuration in LD 27, define conference under FEATID: FEATID aaa mmm <nnn>, where

aaa= A03 (3-party conference) or A06 (6-party conference) mmm = feature activation ID (0 - 127)

nnn = feature indication ID (0 - 127) (If nnn is not entered, it is assumed to be the same as mmm)

3On the ISDN BRI terminal, if the signaling type/protocol is configurable, then select National ISDN-1or ETSI protocol.

4On the ISDN BRI terminal, configure Conference. This procedure largely depends on the implementation of feature key management on individual terminals. In general:

a.The terminal provides Conference as a selectable feature to be programmed on a hard/soft key. For example, on a soft key on an M5317TDX, select FA to be FCC; on a hard key on an M5209TDcp, select CONF.

b.The Conference key number selected on the terminal must correspond to the feature activation ID entered for the TSP in LD 27.

5Configure at least two DN appearances on the ISDN BRI terminals. On some ISDN BRI terminals, the second DN appearance is used to allow the user to initiate the second call.

6Place an outgoing call from the ISDN BRI terminal.

Nortel Communication Server 1000

ISDN Basic Rate Interface Installation and Commissioning

NN43001-318 01.02 Standard

Release 5.0 20 June 2007

Copyright © 2003-2007, Nortel Networks