Transcend Information TS-ABX31 Standby Mode, Suspend Mode, HDD Power Down, Throttle Duty Cycle

Page 33

29

BIOS SETUP

Standby Mode

After the selected period of system inactivity (1 minute to 1 hour), the fixed disk drive and the video shut off while all other devices still operate at full speed.

Suspend Mode

After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU shut off.

HDD Power Down

After the selected period of system inactivity (1 to 15 minutes), the hard disk drive powers down while all other devices remain active.

Throttle Duty Cycle

When the system enters Doze mode, the CPU clock runs only part of the time. You may select the percent of time that the clock runs.

PCI/VGA Active Monitor

When enabled, any video activity restarts the global timer for Standby Mode.

Soft-Off by PWR-BTTN

When set to “Instant-off”, the ATX switch can be used as a normal system power off button. When set to “Delay 4 seconds”, you need to hold the ATX switch for more than 4 seconds if you want to power off system.

Ring Wake Up

This allows either setting of “Enabled” or “Disabled” for powering up the computer when the modem receives a call and the computer is in the soft-off mode.

LAN Wake Up

This allows you to remotely power up your system through your network by sending a wake up frame or signal.

NOTE: This feature requires the network interface and an ATX power supply with at

least 720mA +5 V standby power.

Time Wake Up

This item can power on your computer at the time you selected.

Reload Global Timer Events

When enabled, an event occurring on each device listed below restarts the global timer for Standby mode.

Image 33
Contents Transcend User/s Notice Table of Contents Bios Upgrade Bios SetupPackage Contents Specifications and Features1INTRODUCTION Wake Up Features Award BiosPCB Dimensions INTRODUCTION2Transcend TS-ABX31 Motherboard Hardware InstallationPS/2 Layout of Transcend TS-ABX31 MotherboardCPU Installation CPU Internal Frequency Ratio Setting 66/100MHz System ConfigurationTS-ABX31 CPU Freq.-Ratio DIP Switch Setting DIMM3 Memory ConfigurationKeyboard Wake Up 3-pin KB-AWK Primary / Secondary IDE Connectors Two 40-pin IDEFan Power Connectors Floppy Disk Drive Connector 34-pin FDCIrDA-Compliant Infrared Module Connector 5-pin IrDA Wake-on-LAN Connector 3-pin WOLSpeaker Lead 4-pin Speaker Panel ConnectorsSoftware Power-Off Lead 2-pin Softoff Power Connector 20-pin PwrconnExternal Connectors Clear Cmos Jumper 3-pin JP4 Bios Setup Bios SetupMain Menu Bios Features Setup Standard Cmos SetupChipset Setup Power Management SetupSupervisor / User Password Standard Cmos SetupSave & Exit Setup IDE HDD Auto DetectionBios Setup Drive a / Drive B VideoHalt On Bios Features Setup Virus WarningCPU Internal Cache / External Cache Boot Sequence Quick Power On Self TestBoot Up Floppy Seek Boot Up NumLock StatusReport no FDD for WIN95 Auto Configuration Chipset Features SetupEDO Dram Speed Selection EDO CASx# MA Wait State / EDO RASx# MA Wait StateDram Data Integrity Mode Sdram RAS-to-CAS DelaySystem Bios Cacheable Video Bios CacheableCPU Warning Temperature Delayed TransactionCurrent Power FAN Speed Memory Hold At 15M-16MPower Management Setup Power ManagementAcpi function PM Control by APM Doze ModeVideo Off Method Video Off AfterSuspend Mode Standby ModeHDD Power Down Reload Global Timer EventsPNP OS Installed PnP/PCI Configuration SetupResource Controlled by Reset Configuration DataIRQ-n Assigned to DMA n Assigned toIntegrated Peripherals IDE HDD Block ModeIDE Primary/Secondary Master/Slave PIO IDE Primary/Secondary Master/Slave Ultra DMAOn Chip IDE Primary / Secondary PCI IDE Power on FunctionUSB Keyboard Support Init Display FirstParallel Port Mode Uart Mode SelectOnboard Serial Port Onboard Parallel PortSupervisor Password IDE HDD Auto Detection User PasswordExit Without Saving Save & Exit SetupLoad Bios Defaults Load Setup Defaults How to Check Your Bios File Name and Version Bios UpgradeDownload Correct Bios File from Web How to Update Your Motherboard BiosBios Update