MGE UPS Systems Pulsar TM 30, Pulsar TM EX30, Pulsar TM EX20

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

This manual contains important instructions for Models EX20 / EX30 / EXB20/30 that should be followed during installation and maintenance of the UPS batteries.

cThis equipment can be operated by any individual, with no previous training;

cCAUTION: Risk of electric shock, even with unit disconnected from AC power source. Hazardous voltage still may be present through operation from battery. The battery supply should be disconnected at the plus and minus terminals using the quick disconnect connectors of the battery when maintenance or service work inside the UPS is necessary.

cThe UPS contains voltages which are potentially hazardous. All repairs should be performed by qualified service personnel only;

cdo not attempt to power the UPS from any receptacle other than a 2-pole 3-wire grounded receptacle;

cdo not place Pulsar near water or in environment of excessive humidity;

cdo not allow liquids or any foreign objects to get inside Pulsar;

cdo not block air vents in the back of Pulsar;

cdo not plug household appliances such as hair dryers to Pulsar receptacles;

cdo not place Pulsar in direct sunlight or close to heat-emitting source;

cthe AC power receptacle should be near the equipment and easily accessible. To isolate Pulsar from AC input, remove the input power cord from the AC power receptacle;

cif Pulsar is to be stored for a long time, it is recommended to recharge the batteries (by connecting AC power source to Pulsar, switch "ON" or "OFF"), once a month for 24 hours to avoid a full batteries discharge;

cPulsar contains batteries that should be disposed of or recycled in accordance with local applicable laws;

cprior to installation, store Pulsar in a dry location;

cstorage temperatures must be between –4°F (-20°C) and +113°F (+45°C);

cservicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the required precautions. Keep unauthorized personnel away from batteries;

cwhen replacing the batteries, use the same number and the following type of batteries:

v Pulsar EX20: 8 x 12V - 6.5Ah,

v Pulsar EX30 : 8 x 12V - 7.2Ah;

c~ : alternating current supply symbol;

cCAUTION: do not dispose of battery or batteries in a fire. The battery may explode;

cCAUTION: do not open or mutilate the battery or batteries, released electrolyte is harmful to the skin and eyes. It may be toxic;

cCAUTION: a battery can present a risk of electric shock and high short circuit current. The following precautions should be observed when working with batteries:

v remove watches, rings or other metal objects,

v use tools with insulated handles,

v wear rubber gloves, boots and safety glasses;

cplease dispose of the packaging in accordance with the applicable legislation.

MGE UPS SYSTEMS

Pulsar EX : 51032278XT/AB