MGE UPS Systems Pulsar TM EX30 Getting started, Location, Preliminary checks, Connections

getting started

location

cobserve the safety rules indicated at the beginning of this document.

preliminary checks

ccheck that the "on/off" button " " on the front is not pushed in;

ccheck that rating shown on the rating label corresponds to the input voltage specification and power requirement of the load.

connections

cconnect the AC input cord to the utility power outlet.

	Vac	OUT
								7a
	I max	. 30A		OUT		ress
		Vac
						p
					t			r
					?e
						es
						FUSE		-T
					15A		120V
								7b
						ress
						p
					t			r
					?e
						es
						FUSE		-T
					15A		120V
						ress
						p
					t			r
					?e
						es
					FUSE -T
				15A		120V
PUT		I max	15A
								8

c connection of the Pulsar EXB20/30

battery extension module (optional):

v check that the button "on/off" " " on the

front of the Pulsar EX20/EX30 is not pushed

in,

v disconnect the input connection cord,

v flip the circuit-breaker of the battery unit to

the right (position "O"),

v connect the battery connection cord to the

DC connector of the battery module and

connect to the Pulsar EX20/EX30,

v if the installation has 2 battery modules,

connect the second cord to the DC

connector of the second module and to the

first module,

v the use of connectors is strictly limited to

connecting the battery modules to the

Pulsar EX20/EX30. Any other connection to

UIT ER 5V-T

INPUT

15A		120V
	ress
	p
?e			r
t
	es
	FUSE		-T
15A		120V
	ress
	p
?e			r
t
	es
FUSE -T
15A	120V

I max 15A

utility power receptacle

to computer

loads

Note 1: following connection, the battery automatically charges, whenever plugged in.

Note 2: the batteries will provide full back-up time after approximatively 8 hours of recharge time.

Note 3: if site wiring fault LED 8 is lit and buzzer sounds, line/neutral connections are reversed.

these connectors is prohibited and risks

damaging the battery, not covered by

warranty,

v to start, flip the battery circuit-breaker to

the left (position "I"),

v if your installation is operated with MGE

UPS SYSTEMS software, update your

battery configuration with EX Tuner.

5

cconnect the computer loads to output sockets 7a or 7b .

12 Pulsar EX: E-51032278XT/AB MGE UPS SYSTEMS