RCA 300 manual SpeedTouch on

3 SpeedTouch™ for Microsoft Windows

Step	Action
8	The 'Setup Complete' window pops up to announce that installation is
	finished:
	Click Finish to close the SpeedTouch Setup wizard (application).
9	Plug the ADSL cable, provided in your package, into the receptacle of the
	SpeedTouch™. Plug the other end of the ADSL cable into the wall socket
	terminating ADSL service.
	Note: Depending onto which pins of the wall socket the ADSL signals are
	assigned, it might be necessary to plug in an RJ11 interchanger into the wall
	socket prior to connect the ADSL cable.
10	Plug the SpeedTouch™'s USB connector into the PC's USB port.
	An USB port can be easily located, it is marked with the typical USB symbol:
11	The 'Windows found New Hardware' wizard will automatically continue with
	the installation of the SpeedTouch™ ADSL modem device:
12	The installation continues with the creation of the appropriate PPP Dial-Up
	Networking connections.
13	At the end of the procedure the 'Speed Touch Dial-Up' window pops up,
	allowing you to immediately connect to the Internet (See section “3.2. Using
	the SpeedTouch™” on page 16).
	The installation of the SpeedTouch™ is now finished. The SpeedTouch™ is
	now prepared for connecting you to the Internet.

14 3EC 36714 BAAA TCZZA Ed. 02