Chapter 6
Troubleshooting
6.3 Reset to Factory Defaults
Resetting your SpeedTouch™
You might consider a reset to factory defaults as described below.
! | Be aware that a reset to factory defaults will revoke all configurational |
changes you made to the SpeedTouch™. |
You can choose between:
Hardware reset
Software reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Hardware reset Proceed as follows:
1Make sure the SpeedTouch™ is powered on.
2Use a pen or an unfolded paperclip to push the recessed reset button on the back panel. The reset button is marked with a red circle. Keep it pushed until the power LED lights red - this will take about 7 seconds.
15VAC | ON/OFF | ETHERNET | RESET | DSL |
|
|
|
|
|
|
|
|
|
|
3Release the reset button.
4The SpeedTouch™ restarts.
Software reset Proceed as follows:
1Go to the SpeedTouch™ web pages.
2In the menu select SpeedTouch > Configuration.
3In the Pick a task... list, click Reset my SpeedTouch to default settings.
4The SpeedTouch™ restarts.
5The SpeedTouch™ returns to the SpeedTouch™ Home page (unless the IP address of your computer is not in the same subnet as the default IP address of the SpeedTouch™, being 192.168.1.254).
91 | |
|