American Power Conversion AP8841 Install using the rubber, Feet provided, Connection procedures

Page 9

Install the Switched Rack PDU

a.Insert a caged nut (provided with the enclosure) above and below a notched hole on each vertical mounting rail in your chosen location.

b.Align the mounting holes of the brackets with the installed caged nuts. Insert and tighten screws.

Install using the rubber	1.	Attach the rubber feet to the bottom of the Switched Rack PDU,
feet (provided)		placing one in each corner.
	2.	Place the PDU on an even surface, where it will be accessible for
		connection procedures.

Switched Rack PDU Installation and Quick-Start Manual

5

Image 9

Contents Switched Rack Power Distribution Unit Page Contents How to Download Firmware Updates Warranty and Service Preliminary Information Documentation AdditionalInventory Receiving inspectionInstallation guidelines Install the Switched Rack PDUHow to attach cords to the tray Attach the cordInstall the Switched Rack PDU Connection procedures Install using the rubberFeet provided Placing one in each cornerOverview TCP/IP configuration methods Quick ConfigurationPassword to access the Switched Rack PDU through Option enabled, you can use apc for both the user nameConfiguration Bootp the default settingSee also section in the Addendum Option 43 = 01 04 31 41 50 43 where Local access to Remote access toControl console If you are not using a Bootp or Dhcp server to configure Control console on page 10 or Remote access to the controlWill take effect when you log out If you disconnected a cable during the procedureOverview Web interfaceTelnet How to Recover From a Lost Password Xmodem How to Download Firmware UpdatesLimited warranty Warranty and ServiceWarranty limitations Obtaining serviceGeneral policy Life-Support PolicyExamples of life-support DevicesPage Page Radio Frequency Interference APC Worldwide Customer Support