Install the Switched Rack PDU

Installation guidelines	• If the PDU is installed in an enclosed communications rack, the
	recommended maximum ambient temperature should be no greater
	than 45°C.
	• Install the PDU so that there is air flow to the front and rear face of
	the unit.
	• Install the PDU so that there is not an uneven mechanical load.
	• Follow the nameplate ratings when connecting equipment to the
	supply circuit. Consider the effect that overloading the circuits
	might have on over-circuit protection and supply wiring.
	• Maintain reliable earthing of the PDU. Give particular
	consideration to supply connections that do not directly connect to
	the branch circuit.
	• The PDU does not provide overcurrent protection. Connect the
	PDU to an appropriately rated branch circuit.
	• Install the PDU so that the power plug may be disconnected for
	service.
Attach the cord	Attach the cord retention tray to the Switched Rack PDU, using the four
retention tray	flat-head screws (provided).

How to attach cords to the tray

Attach the cord to the tray by looping the cord and securing it to the tray, using a wire tie.

The cord must be secured to the tray so that you can unplug it from the PDU without removing the wire tie.

Note

Switched Rack PDU Installation and Quick-Start Manual