CONTACTOR REMOVAL AND REPLACEMENT
Caution
This procedure requires the system to be powered down.
11To remove and replace the contactor, proceed as follows:
11.1Switch off and isolate the external power system and check that the contactor is de- energised.
11.2Disconnect the output cable at the battery end and wrap with two layers of insulating tape.
11.3Open the door, remove five screws and washers on the plastic plate and lift off the plate.
11.4Remove two nuts on FS1 and lift off the fuse.
11.5Remove five nuts and washers holding the contactor to the two adjacent copper bars and remove the curved copper bar.
11.6Remove the eight
11.7Remove four nuts and washers on the base of the bracket and lift the bracket and contactor out of the unit.
11.8Remove three nuts and washers on the bracket and lift off the contactor.
11.9Fit a replacement contactor to the bracket using three nuts and washers.
11.10Secure the contactor and bracket in the unit using four nuts and washers.
11.11Refit the eight
11.12Refit the curved copper bar and the contactor to the adjacent copper bars using five screws and washers.
11.13Refit FS1 using two nuts and washers.
11.14Refit the plastic plate using five screws and washers and close the door.
11.15Remove the insulating tape from the output cable and connect to the battery negative terminal.
11.16Power up the system as detailed in Section 5 Para 8.
Text artwork | Page 15 of 20 |