APC 208 Vac Maintenance, Transport, and Service, Replace battery modules, Install new batteries

Page 21

Maintenance, Transport, and Service

Replace battery modules

This UPS has easy-to-replace, hot-swappable battery modules. Replacement is a safe procedure, isolated from electrical hazards. You may leave the UPS in the rack and connected equipment on during the replacement procedure.

Once the batteries are disconnected the connected equipment is not protected from power outages.

Refer to the appropriate replacement battery user manual for battery module installation instructions. See your dealer or contact APC at www.apc.com for information on replacement battery modules.

Be sure to deliver the spent battery(s) to a recycling facility or ship it to APC in the replacement battery packing material.

Open battery doors

4x

Remove spent batteries from the UPS

Pull the battery disconnect cords attached to the battery connectors. DO NOT pull the battery cables to disconnect the batteries.

Battery disconnect cord

Install new batteries

Smart-UPS 5000 VA 208/230 Vac Tower/Rack-Mount 5U User Manual

17

For further information contact UPS Direct Ltd:

Tel: 08456 445 002 - Fax: 08456 445 003 - Email: info@upsdirect.com - Website: www.upsdirect.com

Image 21

Contents APC Smart-UPS≤ Page Contents Page Read the Safety Guide before installing the UPS About this UPSUnpack Installation SpecificationsRack-mount configuration Install rack-mount brackets and rail cleatsInstall unit in rack Rack-mount to tower conversion procedure Install stabilizer bracketsInstall two top covers Input hardwire 230 V models only AccessoriesConnect the ground wire prior to connecting the line wires Configure bezel Rack-mount configuration Tower configurationConnect batteries Rack-mount configuration Connect display cable and install bezelConnect Equipment and Power to the UPS Rear PanelsStart the UPS Communication Ports Emergency Power OffIndicator Indicator Title Description Display Panel Indicators and Function ButtonsDisplay Panels ModelsFeature Feature Title Function Button Function Factory User Selectable Description Default Choices UPS settingsBrightly Problem and/or Possible Cause Solution TroubleshootingReplace Battery/Battery Disconnected LED is illuminated Input circuit breaker tripsAVR Boost or AVR Trim LEDs are illuminated UPS operates on battery although line voltage exists There is no utility powerBattery Charge and Load LEDs flash simultaneously Diagnostic utility voltageMaintenance, Transport, and Service Replace battery modulesInstall new batteries Service Terms of warranty Two-Year WarrantyDate of product declaration