APC 208 Vac user manual Rack-mount to tower conversion procedure, Install stabilizer brackets

Page 8

Rack-mount to tower conversion procedure

The UPS and the battery modules are heavy. Remove the battery modules to lighten the UPS during installation. Refer to the battery removal instructions on the packaging.

Install stabilizer brackets

Stand the UPS on the side with the embossed marks.

Secure a stabilizer bracket (supplied), to both sides of the UPS.

Secure each bracket with two pan head locking screws (supplied).

4x

Install two top covers

Install the large top cover by placing it in the slots on the UPS and sliding the cover forward.

Install the small top cover by placing it in the slots on the UPS and sliding the cover forward.

Secure the top covers with a #8 black screw (supplied).

Install batteries

Connect only the first two batteries in the string of three batteries. Be sure that the battery connectors are fully engages.

Do not connect the single battery or the last battery installed in the string of three batteries.

Close and secure the battery doors

2x

Foam spacers

2x

4	Smart-UPS 5000 VA 208/230 Vac Tower/Rack-Mount 5U User Manual

For further information contact UPS Direct Ltd:

Tel: 08456 445 002 - Fax: 08456 445 003 - Email: info@upsdirect.com - Website: www.upsdirect.com

Image 8

Contents APC Smart-UPS≤ Page Contents Page Unpack Read the Safety Guide before installing the UPSAbout this UPS Specifications InstallationRack-mount configuration Install rack-mount brackets and rail cleatsInstall unit in rack Install two top covers Rack-mount to tower conversion procedureInstall stabilizer brackets Connect the ground wire prior to connecting the line wires Input hardwire 230 V models onlyAccessories Connect batteries Configure bezelRack-mount configuration Tower configuration Connect display cable and install bezel Rack-mount configurationStart the UPS Connect Equipment and Power to the UPSRear Panels Emergency Power Off Communication PortsDisplay Panel Indicators and Function Buttons Indicator Indicator Title DescriptionDisplay Panels ModelsFeature Feature Title Function Button UPS settings Function Factory User Selectable Description Default ChoicesBrightly Troubleshooting Problem and/or Possible Cause SolutionAVR Boost or AVR Trim LEDs are illuminated Replace Battery/Battery Disconnected LED is illuminatedInput circuit breaker trips There is no utility power UPS operates on battery although line voltage existsBattery Charge and Load LEDs flash simultaneously Diagnostic utility voltageInstall new batteries Maintenance, Transport, and ServiceReplace battery modules Service Two-Year Warranty Terms of warrantyDate of product declaration