APC 208 Vac user manual Specifications, Installation, Rack-mount configuration

Page 6

Specifications

Temperature

32° to 104° F (0° to 40° C)

This unit is intended for indoor use

Operating

only. Select a location sturdy enough

Storage

5° to 86° F (-15°to 30° C) charge the UPS battery every six months

to handle the weight.

 

86° to 113° F (30° to 45° C) charge the UPS battery every three months

Do not operate the UPS where there

 

is excessive dust or the temperature

Maximum

 

or humidity are outside the specified

 

limits.

Elevation

 

 

Environmental factors impact battery

Operating

6562 ft (2,000 m)

life. High temperatures, poor utility

Storage

50,000 ft (15,240 m)

power, and frequent, short duration

 

 

discharges will shorten battery life.

 

 

 

Humidity

0 to 95% relative humidity, non-condensing

 

 

 

 

Weight

215 lbs (98 kg) with battery module

215 lbs (98 kg)

 

107 lbs (49 kg) without battery module

 

 

27 lbs (12 kg) each battery module

 

 

 

 

NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an additional label is located on the chassis under the front bezel.

Installation

Rack-mount configuration

This unit is intended for mounting in a four post rack. To order a two post rack-mount kit contact your dealer or refer to the APC Web site, www.apc.com.

The UPS and the battery modules are heavy. Remove the battery modules to lighten the UPS during installation. Refer to the battery removal instructions on the packaging.

Install rack-mount brackets and rail cleats

Four screws must be used to secure each rail bracket and rail cleat to the UPS. One rack-mount bracket and one rail cleat must be secured to the both sides of the UPS.

Rack-mount bracket

four post rack-mount position

Rail cleat

4x 4x

2

Smart-UPS 5000 VA 208/230 Vac Tower/Rack-Mount 5U User Manual

For further information contact UPS Direct Ltd:

Tel: 08456 445 002 - Fax: 08456 445 003 - Email: info@upsdirect.com - Website: www.upsdirect.com

Image 6
Contents APC Smart-UPS≤ Page Contents Page Read the Safety Guide before installing the UPS About this UPSUnpack Rack-mount configuration SpecificationsInstallation Install rack-mount brackets and rail cleatsInstall unit in rack Rack-mount to tower conversion procedure Install stabilizer bracketsInstall two top covers Input hardwire 230 V models only AccessoriesConnect the ground wire prior to connecting the line wires Configure bezel Rack-mount configuration Tower configurationConnect batteries Connect display cable and install bezel Rack-mount configurationConnect Equipment and Power to the UPS Rear PanelsStart the UPS Emergency Power Off Communication PortsDisplay Panels Display Panel Indicators and Function ButtonsIndicator Indicator Title Description ModelsFeature Feature Title Function Button UPS settings Function Factory User Selectable Description Default ChoicesBrightly Troubleshooting Problem and/or Possible Cause SolutionReplace Battery/Battery Disconnected LED is illuminated Input circuit breaker tripsAVR Boost or AVR Trim LEDs are illuminated Battery Charge and Load LEDs flash simultaneously There is no utility powerUPS operates on battery although line voltage exists Diagnostic utility voltageMaintenance, Transport, and Service Replace battery modulesInstall new batteries Service Two-Year Warranty Terms of warrantyDate of product declaration