3Com PSE2500-A3 user manual Controller, 2Front panel of the rectifier

Page 14

User Manual

 

PSE2500-A3 External PoE

Chapter 2 System Description

Power System

Figure 2-2Front panel of the rectifier

2.2 Controller

The system controller of PSE2500-A3 is installed within the chassis. See figure 2-3.

Figure 2-3Front panel of the controller

There are green LED (RUN) indicating operation status and red LED (ALM) indicating the alarm on the front panel of the PSE2500-A3 controller. When the system has an alarm, such as input failure, input over-voltage or under-voltage, output over-voltage or under-voltage,

2-3

Image 14
Contents PSE2500-A3 External PoE Power System Technical Support Chapter Contents About This ManualConvention Description Boldface Convention DescriptionEnvironmental Protection Table of Contents Engineering Maintenance and Troubleshooting Introduction Architecture and ConfigurationsDescription Standard Configuration Description Standard Configuration Features 2PSE2500-A3 configuration3PSE2500-A3 configuration System Description OverviewFault Green Red ConditionController 2Front panel of the rectifierMonitoring the system operation status II. Communicate with deamon systemsRS232 Pin Definition RS485 Pin DefinitionPin Definition AC Distribution UnitDC Distribution Unit Safety Safety StatementsPSE2500-A3 External PoE Power System Safety Precautions PSE2500-A3 External PoE Power System Safety Installation and Debugging IntroductionSafety Physical Mounting Installing Rectifiers 1Physical installation2Installing rectifiers Frame GroundingLoad Connections 3Frame groundingInitial Start-up Connecting to AC utility/ AC groundingPowering on the Device PSE2500-A3 External PoE LED Indication Engineering Maintenance TroubleshootingMaintenance and Troubleshooting Controller Rectifier Possible Alarm Display Problems Status Possible solutionDiscipline Standards Regulatory compliance standardsController Rectifier Possible