Spartan Operation and Maintenance Manual
5.2 Roller pressure handle | Laminating position |
The roller pressure handle sets the roller nip opening for the desired application with the material being used.
INFORMATION: Never attempt to alter the factory preset settings for the nip opening or speed. Contact your local service representative if you feel the roller pressure handle requires calibrating.
Roller release position
–Use this position when running film pouch type materials. The is the minimum nip opening position. This nip opening and speed is preset for GBC materials.
5.3 ON/ OFF power switch
–Use this position when the laminator is not in use or no nip pressure is required. This is the maximum nip opening position.
The power ON/ OFF turns your laminator on. When the laminator is on, the rollers begin heating automatically.
Foam pouch position
–Use this position when using board type materials through the laminator. This nip opening and speed is preset for GBC materials.
(O) This is the OFF position for the laminator.
CAUTION: During long periods of no use, 30 minutes or greater, you should turn power off to the laminator. This will prevent hot spots from forming on the rollers.
Page | © 2004 General Binding Corporation |