GBC 930-073 manual Mounting boards

Page 20

Spartan Operation and Maintenance Manual

6.2 Mounting boards

1.Turn the laminator on.

2.Center the image on the board under the protective sheet.

Protective sheet

Image

Board

3.Set the pressure handle to the foam pouch position.

4.Wait for READY to illuminate.

5.Press RUN.

+

7.Gently slide the mounting board into the roller nip until you feel the rollers catch the board.

8.Support the board as it exits the rear of the laminator.

9.Press STOP and set the pressure handle to the roller release position.

+

10.Pull the protective layer off the board and trim to desired size.

Protective layer

6.Align the leading edge of the mounting board slightly off center of the table.

Page 6-2

© 2004 General Binding Corporation

Image 20

Contents Spartan Laminator Part Number 930-073 Rev a Rev. DateGBC Table of contents General Binding Corporation Explanation of symbols SafetyGeneral rules of safety Primary function Safety decals Pouches 25 per boxMounting Boards 10 per box Pouchboards clear 10 per boxCuidado Spartan Operation and Maintenance Manual Warranty Limited WarrantyExclusions to the Warranty This warranty specifically does not coverThis page intentionally left blank Specifications Dimensions and weightElectrical Consumable132 cm 105 cm 18.5 46 cm Installation Pre-installationSuggested floor layout 1 Suggest floor layout exampleKnow your laminator Unpacking Operations Control PanelON/ OFF power switch Roller pressure handleLaminating position Roller release positionApplications Pouch boardsMounting boards Lamination pouches Laminating Pouches Helpful HintsPouch Boards Maintenance Cabinets, cover and standRollers Stains/ dust on rollersAdhesive on rollers Page General Binding Corporation One GBC Plaza Northbrook, IL