Spartan Operation and Maintenance Manual
2.0 Warranty
GBC Films Group warrants the equipment to be free from defects in material and workmanship for a period of 90 days for parts and labor from the date of installation. This warranty is the only warranty made by GBC Films Group and cannot be modified or amended.
GBC Films Group’s sole and exclusive liability and the customer’s sole and exclusive remedy under this warranty shall be, at GBC Films Group’s option, to repair or replace any such defective part or product. These remedies are only available if GBC Films Group’s examination of the product discloses to GBC Films Group’s satisfaction that such defects actually exist and were not caused by misuse, neglect, attempt to repair, unauthorized alteration or modification, incorrect line voltage, fire, accident, flood or other hazard.
2.1 Limited Warranty
This warranty specifically does not cover damage to the laminating rollers caused by knives, razor blades, other sharp objects, failure caused by adhesives or improper use of the machine. Warranty repair or replacement does not extend the warranty beyond the initial 90 day period from the date of installation.
CAUTION: Unauthorized customer alterations will void this warranty.
THE WARRANTY MADE HEREIN IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. GBC FILMS GROUP WILL NOT BE LIABLE FOR PROPERTY
DAMAGE OR PERSONAL INJURY ( UNLESS PRIMARILY CAUSED BY ITS NEGLIGENCE ), LOSS OF PROFIT OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE EQUIPMENT.
2.2 Exclusions to the Warranty
This warranty specifically does not cover;
1.Damage to the laminating rolls caused by knives, razor blades, other sharp objects or failure caused by adhesives.
2.Damage to the machine caused by lifting, tilting and/or any attempt to position the machine other than rolling on the installed castors on even surfaces.
3.Improper use of the machine.
4.Damage due from unqualified person(s) servicing the machine.
Qualified;
•Any engineer that has experience with electrical and mechanical design of lamination equipment. The engineer should be fully aware of all aspects of safety with regards to lamination equipment.
•Any commissioning or service engineer must be of competent nature, trained and qualified to GBC Films Group standards to fulfill that job. This person will have completed and passed the full service training course from GBC Films Group.
•Any GBC Technician, GBC Specialist, and / or GBC Films Group Technician that has been through the GBC Films Group service training course.
© 2004 General Binding Corporation | Page |