GBC 930-115 manual Operator Screens, Speed Screen

Operations Manual Polaris II

5.3 Operator Screens

The Touch screen has five operator screens. The following is a description of each screen:

SPEED SCREEN

13 4

2

	0 SPEED
			T	C
	0 COUNT				5
-	LAPOVER	+
			R	M

7 <--- ---> 6

8

(1)SPEED: Displays current speed of machine in ft/min.

(2)COUNT: Displays the current job count. The counter increaments every time the knife makes a pass over the conveyor while the laminator is running. To reset the counter, press the “R” button on this screen.

(6)R: Reset Counter. This button resets the current job counter to 0.

(7)OVER LAP +/-:Pressing the “+” button increases the over lap between sheets while pressing the “-” button decreases the over lap.

(8)SCREEN NAVIGATION: The arrow buttons move from one screen to the next. These buttons work the same on all of the operator screens.

MISC SERVICE SCREEN

1		3	2
COMP	SERV		KNIFE
OFF			ON
<---		--->

(3)T: This is a display tool only. When the symbol turns to a black background with a white “T”, the temperature of the lamination roll had reached the set point and laminator is ready to run.

(4)C: This is a display tool only. The symbol turns to a black background with a white “C”, when all of the safety covers are closed.

(5)M: Misfeed override. When setting up the feeder, the operator may want to override the misfeed sensor. Pressing this button will override the alarm and allow the machine to run while allowing gaps between the sheets. When the button is black with a white “M”, the misfeed sensor is active and will stop the machine when gaps between the sheets are larger than 1/4”. When the button is white with a black “M”, the misfeed sensor is overridden. It is not recommended to laminate while the misfeed sensor is overridden because film may stick to the nip roll and cause a wrap up.

(1)COMP OFF/COMP ON: This button toggles the compressor on and off.

(2)KNIFE ON/KNIFE OFF: This activates the knife to cut when the over lap sensor is covered. Turning the knife off prevents the knife from activating when the over lap sensor is covered.

(3)SERV: These buttons are reserved for GBC Service Technicians.

© 2004 General Binding Corporation Page 5-7