Polaris II | Operations Manual |
|
|
(9) The cutter On/Off indicator is to be off during the | Figure 6.1.3 Film Leader |
webbing process. |
|
WARNING: Roller are HOT. Use extreme caution when loading film. Direct contact with the rollers can burn you!
(10)Lift the main roller safety shield for ease of webbing the film.
(11)Pull the laminating film down under the rubber idler, and over the heat roller and allow film to drape down freely.
(12)Adhere a threading card (a piece of heavy stock paper, card board, or similar product) to the film to help guide the film through the nip. See Figure 6.1.3.
CAUTION: The threading card should exceed the width of the film to prevent activated adhesives from adhering to the bottom roller.
(13)Slide the threading card between the nip roller and the heat roller. Push the threading card into the nip of the main rollers and through the main rollers.
(14)Guide the threading card under the idler roller in front of the decurling bar, then over the decurling bar.
(15)Guide the threading card through the pull rolls. See Figure 6.1.3.
(16)Lower the pull roller with the pull roller knob.
(17)Insert another sheet into the nip of the main roller and the nip roller.
LEADER ATTACHED TO FILM
FRONT OF MACHINE
REAR OF MACHINE
LEADER MUST EXTEND
PAST SKEW WHEELS
(20)Press Start.
(21)Press Cutter ON/OFF to turn off the knife.
(18)Close all guards.
(19)Home the knife by pressing Cutter ON/OFF.
CAUTION: Ensure the safety shields are in the fully closed position.
INFORMATION: When Start is pressed, the machine will have a short pause. This allows the operator to walk to the rear of the machine to help guide the threading card through the machine.
Page | © 2004 General Binding Corporation |