Oki PAGE 18 quick start Check the Settings, Select the Language for the Front Panel Display

Page 31

7 Check the Settings

Select the Language for the Front Panel Display

The printer comes set for front panel display in English. To change it to another language:

1Press ON LINE. Printer goes off line.

2Press and hold MENU 1/Menu 2 until PRINT MODE appears on the display.

3Press MENU 1/Menu 2 repeatedly until LANGUAGE appears on the display.

4Press ENTER.

5Press ♣/Reset repeatedly until the language you want appears on the display.

6Press ENTER.

An asterisk appears next to the language.

7Press ON LINE.

The printer saves the new setting and exits the menu.

Set the Power Save Delay & Quiet Mode

The Power Save Delay and Quiet Mode settings save energy and provide quieter operation when the printer is not printing. However, when these settings are engaged and a print job is received, the printer must warm up before printing.

!For more information, see Adjusting the Warm-up Cycle under Printer Menus in the Printer Control

section of the User’s Guide.

Factory settings: Power Save Delay = 5 minutes, Quiet Mode = ON.

Quick Start E-31

Image 31

Contents Quick Start Page Or by email to By mail toOverview Quick Start E-5 Unpack Remove ContentsSelect a Suitable Location Check the Contents Getting to Know Your Printer Before You ContinueFront View Rear View Image drum Prepare the Image DrumReinstall the drum Prepare the Toner Install the TonerInstall the Toner in the Printer Make Connections Connect to PowerCable Requirements Connect to the Computer PC SystemsParallel Port ConnectionParallel Interface Pin Assignments Standard Parallel Interface Menu SettingsSerial Port Compatibility ModesStandard RS232-C Serial Menu Settings Ethernet Port Model 18n only Model 18n Network Version Connect to the Computer Macintosh SystemsPaper Tray Tray Load PaperLoading Paper Adjust the guides to fit the paper Load Tray Selecting Paper Size & Media Type Paper Tray GaugeFront Feeder Quick Start Envelopes Standard PaperTransparencies LabelsTop Exit Auto SwitchingPaper Exit Paths Manual Feed PrintingRear Exit To use the rear paper exit Pivot out the extenders Printer goes off line Print the DemoPrinter goes back on line, ready to receive data Select the Language for the Front Panel Display Check the SettingsSet the Power Save Delay & Quiet Mode Printer saves the new setting and exits the menuPrinter saves the new settings and exits the menu Current Power Save Delay setting appears on the displayAn asterisk appears next to the new setting Current Quiet Mode setting appears on the displayPrint the Font Set the EmulationTypeface list for the selected emulation prints No CD-ROM Drive? Install the Driver & SoftwareOkipage 18 CD Available Choices for Macintosh SystemsTypical Installation for PC SystemsAvailable Installations Available Registration OptionsRunning the Electronic Registration Program Installation for Windows 95, 98, NTWait for the OKI Menu Installer Setup window to Installation for WindowsLicense Agreement appears Installation for Macintosh SystemsInstalling the Adobe PostScript Level 2 Driver Selecting the PrinterUninstalling the Software LED Display Front Panel SummaryPress and hold 2-3 sec Enters the Level-2 menu ButtonsPress and hold 2-3 sec Prints the Demo Need Support or Service? Operating System Order # No CD-ROM Drive?Windows 95/98/NT 4.0 Click Start on the Windows