Oki PAGE 18 Connect to the Computer PC Systems, Parallel Port, Connection, Cable Requirements

Page 15

Connect to the Computer:

PC Systems

Parallel Port

Connection

!For the best results, use a bi-directional parallel printer cable marked IEEE 1284-compliant.

1Printer and computer OFF.

2Insert the connector, secure with the clips.

3Connect to the computer; tighten the screws.

!Be sure not to over-tighten the screws–this could damage the screw posts on your computer.

4Turn the printer and computer on.

Cable Requirements

To comply with FCC regulations, the cable must be shielded with twisted pair conductors, and must be UL and CSA approved.

Maximum length for standard bi-directional cable is 6 feet (1.8 meters). For lengths greater than 6 feet, use a cable marked IEEE 1284-compliant.

Printer connector is IEEE 1284-B receptacle (36 pins,

0.085" center line).

Port supports bi-directional IEEE 1284 communications (compatibility, nibble, and ECP modes).

Quick Start E-15

Image 15

Contents Quick Start Page Or by email to By mail toOverview Quick Start E-5 Remove Contents UnpackSelect a Suitable Location Check the Contents Before You Continue Getting to Know Your PrinterFront View Rear View Image drum Prepare the Image DrumReinstall the drum Prepare the Toner Install the TonerInstall the Toner in the Printer Make Connections Connect to PowerCable Requirements Connect to the Computer PC SystemsParallel Port ConnectionParallel Interface Pin Assignments Standard Parallel Interface Menu SettingsSerial Port Compatibility ModesStandard RS232-C Serial Menu Settings Ethernet Port Model 18n only Model 18n Network Version Connect to the Computer Macintosh SystemsLoad Paper Paper Tray TrayLoading Paper Adjust the guides to fit the paper Load Tray Selecting Paper Size & Media Type Paper Tray GaugeFront Feeder Quick Start Envelopes Standard PaperTransparencies LabelsTop Exit Auto SwitchingPaper Exit Paths Manual Feed PrintingRear Exit To use the rear paper exit Pivot out the extenders Print the Demo Printer goes off linePrinter goes back on line, ready to receive data Select the Language for the Front Panel Display Check the SettingsSet the Power Save Delay & Quiet Mode Printer saves the new setting and exits the menuPrinter saves the new settings and exits the menu Current Power Save Delay setting appears on the displayAn asterisk appears next to the new setting Current Quiet Mode setting appears on the displaySet the Emulation Print the FontTypeface list for the selected emulation prints No CD-ROM Drive? Install the Driver & SoftwareOkipage 18 CD Available Choices for Macintosh SystemsTypical Installation for PC SystemsAvailable Installations Available Registration OptionsRunning the Electronic Registration Program Installation for Windows 95, 98, NTWait for the OKI Menu Installer Setup window to Installation for WindowsLicense Agreement appears Installation for Macintosh SystemsInstalling the Adobe PostScript Level 2 Driver Selecting the PrinterUninstalling the Software LED Display Front Panel SummaryPress and hold 2-3 sec Enters the Level-2 menu ButtonsPress and hold 2-3 sec Prints the Demo Need Support or Service? No CD-ROM Drive? Operating System Order #Windows 95/98/NT 4.0 Click Start on the Windows