Oki PAGE 18 quick start Standard RS232-C Serial Menu Settings

Page 17

2Insert the connector; secure with the screws.

3Attach to the computer and tighten the screws.

!Be sure not to over-tighten the screws–this could damage the screw posts on your computer.

4Turn the printer and computer on.

!For Serial Interface pin assignments, see Interface in the Specifications section of the User’s Guide.

Cable Requirements

Cable must be shielded with twisted pair conductors and must be UL and CSA approved.

Maximum length for serial cable is 6 feet (1.8 meters).

Printer connector is Type 17LE-13250-27 (D4CC) receptacle (25 pins).

Standard RS232-C Serial Menu Settings

Flow Control = DTR Hi

Baud Rate = 9600 Baud

Data Bits = 8 Bits

Parity = None

Min. Busy = 200 mSeconds

!To change any of these settings, see Printer Menus in the Printer Control section of the User’s Guide.

Quick Start E-17

Image 17

Contents Quick Start Page Or by email to By mail toOverview Quick Start E-5 Select a Suitable Location Remove ContentsUnpack Check the Contents Front View Before You ContinueGetting to Know Your Printer Rear View Image drum Prepare the Image DrumReinstall the drum Prepare the Toner Install the TonerInstall the Toner in the Printer Make Connections Connect to PowerParallel Port Connect to the Computer PC SystemsConnection Cable RequirementsSerial Port Standard Parallel Interface Menu SettingsCompatibility Modes Parallel Interface Pin AssignmentsStandard RS232-C Serial Menu Settings Ethernet Port Model 18n only Model 18n Network Version Connect to the Computer Macintosh SystemsLoading Paper Load PaperPaper Tray Tray Adjust the guides to fit the paper Load Tray Selecting Paper Size & Media Type Paper Tray GaugeFront Feeder Quick Start Envelopes Standard PaperTransparencies LabelsPaper Exit Paths Auto SwitchingManual Feed Printing Top ExitRear Exit To use the rear paper exit Pivot out the extenders Printer goes back on line, ready to receive data Print the DemoPrinter goes off line Set the Power Save Delay & Quiet Mode Check the SettingsPrinter saves the new setting and exits the menu Select the Language for the Front Panel DisplayAn asterisk appears next to the new setting Current Power Save Delay setting appears on the displayCurrent Quiet Mode setting appears on the display Printer saves the new settings and exits the menuTypeface list for the selected emulation prints Set the EmulationPrint the Font Okipage 18 CD Install the Driver & SoftwareAvailable Choices for Macintosh Systems No CD-ROM Drive?Available Installations Installation for PC SystemsAvailable Registration Options TypicalRunning the Electronic Registration Program Installation for Windows 95, 98, NTWait for the OKI Menu Installer Setup window to Installation for WindowsInstalling the Adobe PostScript Level 2 Driver Installation for Macintosh SystemsSelecting the Printer License Agreement appearsUninstalling the Software LED Display Front Panel SummaryPress and hold 2-3 sec Enters the Level-2 menu ButtonsPress and hold 2-3 sec Prints the Demo Need Support or Service? Windows 95/98/NT 4.0 Click Start on the Windows No CD-ROM Drive?Operating System Order #