4.Connect the USB storage device.
5.Press 
.
6.Select [Setup] > [TV settings] >
[Preferences] > [Channel list copy] > [Copy to TV], then press OK.
The channel list is copied to the TV storage device.
7. Disconnect the USB storage device.
Step 3: If the second TV has no channels installed
1.Switch on the second TV (on which you want to copy the channel list).
2.Press 
.
3.Select [Setup] > [Search for channels] > [Reinstall channels], then press OK.
The country menu is displayed.
4.Make sure that the country setting is the same as for the first TV.
5.Press 
.
6.Press [Cancel] to exit.
7.If the country setting is different, reinstall
the second TV to match the country setting of the first TV. See Set up your TV > Restore default settings (Page 41).
8.Connect the USB storage device to the second TV.
9.Press 
.
10.Select [Setup] > [TV settings] > [Preferences] > [Channel list copy] > [Copy to TV], then press OK.
The channel list is copied to the second TV.
11.Disconnect the USB storage device.
Satellite settings
What you can do
View satellite channels
Note: Available on certain models only. [Search for satellite] is only available if the TV supports
To receive satellite channels, connect the SAT connector on your TV to a satellite dish antenna.
LNBs |
| |
| ||
This TV can receive signals from 4 different | English | |
low noise | ||
| ||
An LNB is mounted at the end pole of the |
| |
dish antenna and captures signals from a |
| |
satellite. |
|
Install satellite channels
1. While you watch TV, press 
.
2.Select [Setup] > [Search for satellite] > [Reinstall channels].
3.Follow the onscreen instructions to complete the installation.
4.Once complete, select [Finish], then press OK.
Select connection type
While you install satellite channels, you need to set the connection type. The connection type determines the number of LNBs on your dish antenna and the number of satellite channels you can install.
1.After you select [Reinstall channels], select [Settings] and then press OK.
2.Select [Connection type].
3.Select a setting, then press OK.
∙[One LNB]: Select if you have only one LNB.
∙[DiSeqC Mini (2 LNBs)]: Select if you have 2 LNBs.
∙[DiSeqC 1.0
Test signal strength
If a channel or transponder is skipped during installation, you can test the signal strength of a satellite or add a new channel.
1. While you watch TV, press 
.
2.Select [Setup] > [Search for satellite] > [Manual installation], then press OK.
3.Select the LNB.
4.If you know the frequency of the
transponder (which can include several channels), select [Frequency] and enter it.
5.Select [Search], then press OK.
6.If a new frequency is found, press [Store]to add the new transponder with its channels.
EN 37
