If you can't see the [TV Recording] button, make sure that the programme guide data is
set to be updated through the network. Select 
> [Setup] > [TV settings] >
[Preferences] > [Programme guide] > [From network].
Install USB hard drive
To record TV shows, you must connect a USB hard disk to the TV and format it.
If the TV does not recognise the USB hard drive, use a PC to format it to NTFS file system, then try again.
Caution:
∙TP Vision is not responsible if the hard disk is not supported, nor is it responsible for damage to or loss of data in the device.
∙Formatting removes all data from the connected hard disk.
∙The USB hard drive is formatted exclusively for this TV. Keep it permanently connected to the TV. You cannot access the USB hard drive contents from another TV or PC.
∙Do not overload the USB port. If you connect a USB hard drive device that consumes more than 500mA power, make sure that it is connected to its own external power supply.
1.Make sure that the TV and the USB hard drive are switched off.
2.Make sure that there are no other USB devices connected to the TV.
3.Connect the USB hard drive directly to the TV, or if you intend to connect other USB devices in future, connect the USB hard drive through a USB hub.
Note: While you are formatting the USB hard drive, do not connect other USB devices to the TV.
EN 24
4.Switch on the TV and the USB hard drive, if it has an external power source.
5.Switch to a digital TV channel.
6.Press 
to start formatting.
7.Follow the onscreen instructions to complete the formatting process.
Warning: The formatting process may take some time. Do not switch off the TV or disconnect the USB hard drive until this process is complete.
Start recording
To record the programme you are currently watching, you can use the 
button on the remote control:
1.While you watch TV, press 
. Recording starts immediately. A
2.Select [Schedule], then press OK to confirm the end time.
To stop recording at any time, press 
.
