Epson 220 manual Installing the Ribbon Cartridge, Separator Ribbon-tightening knob

Page 24

EPSON LQ-2080

Installing the Ribbon Cartridge

Warning:

If you just used the printer, the print head may be hot; let it cool before you replace the ribbon cartridge.

Caution:

Make sure the printer is off and unplugged from the electrical outlet. Moving the print head while the printer is on may damage the printer.

1.Make sure the printer is turned off. If the printer is connected to an electrical outlet, unplug it from the outlet.

2.Lift the printer cover by its back edge and then pull it straight up and off.

3.Slide the print head to the ribbon installation position (the indented portion of the paper tension unit) by hand.

Note:

When you use the pull tractor, you can replace the ribbon cartridge even when the print head is not in the ribbon installation position.

ribbon installation position

5.After you remove the new ribbon cartridge from the package, remove the separator from the middle of the ribbon cartridge and discard the separator. Then turn the ribbon-tightening knob in the direction of the arrow to remove any slack in the ribbon.

separator

ribbon-tightening knob

6.Hold the cartridge with the ribbon-tightening knob up. Fit the two front notches (?) of the ribbon cartridge over the small pegs on each side of the printer as shown below. Then lay the cartridge flat so that the rear notches (@) fit over the corresponding pegs.

4.If a cartridge is installed, grasp the cartridge and pull it slightly forward and up; the ribbon guide snaps away from the metal pins behind the print head. Properly dispose of the used ribbon cartridge.

ribbon guide

7.Gently press down the cartridge until both ends click into place.

8.Lift the ribbon guide of the ribbon cartridge (?) and insert it firmly over the metal pins behind the print head (@). Make sure the ribbon is not twisted or creased and that it is in place behind the print head. Press down the guide until it clicks into place.

ribbon guide

ribbon-tightening knob

24 - EPSON LQ-2080

2/99

Image 24
Contents User Replaceable Parts OptionsPaper Handling Options Printer Specifications Optional Interface CardsMechanical Model number NameElectrical EnvironmentalPaper Envelopes top entry only Postcards Front and top entryContinuous paper with labels front and bottom entry Roll paper Rear entry with optional roll paper holder onlyPaper Alignment Printable AreaSafety Approvals Control Panel Buttons and LightsCE Marking Error Indicators Status Monitor Paper PositionsAvailable Paper Paths Using a pull tractor optional Using the push and pull tractors in combinationPaper slot Description Combination DescriptionPaper Release Lever Positions Printing on Single SheetsLoading paper in the top slot Loading paper in the front slotPaper Thickness Lever Positions Paper HandlingLoading Multipart Forms Loading Continuous Paper with LabelsUsing the Front Push Tractor optional Installing the tractor in the front push positionRemoving continuous paper with labels Loading paper onto the front push tractor Removing the printed document from the front push tractor Using the Rear Push Tractor Removing the front push tractorLoading paper onto the rear push tractor Front of the printer Using the Tractor in the Pull Position Installing the tractor in the pull positionRemoving the printed document from the rear push tractor Loading paper onto the pull tractor Attach the printer cover and close the paper guide cover Using two tractors in a push and pull combination Removing paper from the pull tractorSwitching to printing on single sheets Switching to printing on continuous paperRemoving the pull tractor Adjusting the Top-of-Form Position Advancing the Paper to the Tear-Off EdgeUsing the Tear Off/Bin button Adjusting the tear-off positionAdvancing paper to the tear-off position automatically Installing the Ribbon Cartridge Separator Ribbon-tightening knobYour Printer’s Default Settings Settings OptionsClearing Paper Jams Changing Default Settings Aligning Vertical Lines in Your PrintoutPrinting a Self Test Printing a Hex DumpCleaning the Printer Transporting the PrinterRelated Documentation