EPSON LQ-2080
Changing Default Settings
Follow the steps below to enter the
Note:
To print the language selection and
If you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed sheet.
You may exit the
1. Make sure paper is loaded and the printer is turned off.
Caution:
Whenever you turn off the printer, wait at least five seconds before turning it back on; otherwise you may damage the printer.
2.Hold down the Condensed button while you press the Operate button to turn on the printer. The printer enters the
3.Press the Font button until the Font lights indicate the language you want, as described in the language selection instructions.
4.Press the Condensed button to print the
The printed instructions list the default settings you can change, describe how to change them, and show you how the control panel lights help you make settings. Follow these instructions to change the default settings using the buttons on the printer’s control panel.
Note:
The arrows on the instruction sheets indicate the printer’s current settings.
5.When you finish making your settings, press the Operate button to turn off the printer and exit the
Aligning Vertical Lines in Your Printout
If you notice that the vertical lines in your printout are not properly aligned, you can use the printer’s bidirectional adjustment mode to correct this problem.
Note:
To complete the steps below, you need four sheets of
11 inches (279 mm) long and 14.8 inches (376 mm) wide.
If you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed sheet onto the paper guide.
Follow these steps to perform the bidirectional adjustment:
1. Make sure paper is loaded and the printer is turned off.
Caution:
Whenever you turn off the printer, wait at least five seconds before turning it back on; otherwise you may damage the printer.
2.While holding down the Pause button, press the Operate button to turn on the printer. The printer enters the bidirectional adjustment mode and then prints instructions and the first set of alignment patterns.
3.As described in the instructions, compare the alignment patterns and select the pattern with the best alignment.
4.Follow the instructions to print the remaining sets of alignment patterns and select the pattern with the best alignment in each set.
5.After you select the best pattern in the final set of alignment patterns, press the Operate button to turn off the printer and exit the bidirectional adjustment mode. Your selections are saved automatically.
26 - EPSON | 2/99 |