Canon ir3570, ir4570, iR3530, iR2870, iR2270, iR2230 Printer Settings Menu Margin, 10Settings Menu

2

Printer Settings Menu

■Margin

-50.0 to +50.0 mm (in increments of 0.5 mm); 0.0* mm

This setting sets the page margin in millimeters. The settings can be set between -50.0 mm (-1.90 inch) and +50.0 mm (+1.90 inch) in increments of 0.5 mm (0.01 inch).

Use [ ] to increase the width of the inside margin.

Use [ ] to increase the width of the outside margin.

	[0 mm]	[ + ]		[ - ]
	Center		Center		Center
Left Margin		Right Margin

You can specify the edge along which the margin will be created in the Binding Location setting (previous setting). To create a margin along one of the edges of the paper, use this setting in combination with the Binding Location setting.

IMPORTANT

If this setting moves the image outside the printable area, part of the image may be cut off.

NOTE

•If this setting is used in combination with the Offset X/Offset Y setting, the values of the two settings are added together.

• Pressing [ ] increases the setting value by 0.5 mm (0.01 inch) each time the key is pressed.

Pressing [ ] decreases the value by 0.5 mm (0.01 inch) each time. Holding down either [ ]

or [ ] continuously speeds up the value alteration.

2-10Settings Menu