Brady BBP81 Assigning an IP Address, With Dynamic Host Configuration Protocol Dhcp, Without Dhcp

40

Getting Started

Assigning an IP Address

Assigning an IP Address

Before you can begin working with 10/100 Internal PS, you must get or assign an IP address for the 10/100 Internal PS device.

There are three different ways to assign an IP address. Here is a list and a brief description of each method:

•Web View — Browser-enabled method to assign an IP address.

•DHCP — See your LAN administrator for more information.

•Telnet — DOS command to assign an IP address.

Important • Throughout the procedures in this chapter, there are some features that require the default User ID and/or default password. If you are prompted, these are the defaults:

•User ID: admin

•Password: 1234

With Dynamic Host Configuration Protocol (DHCP)

If your network uses DHCP, your 10/100 Internal PS device is assigned a temporary IP address.

Note • Check with your Network Administrator to see whether your network uses DHCP.

Without DHCP

If your network does not use a dynamic IP addressing system (such as DHCP), you need to set a permanent IP address for the 10/100 Internal PS device.

Y885775 BradyConnect 10/100 Internal Print Server User Guide 07/18/2008