Brady BBP81 manual Telnet, To open a telnet session on your PC, complete these steps

Hardware Troubleshooting

Troubleshooting the 10/100 PS

Telnet

Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be used when running Vx.15.x or later firmware. In this example, a ZPL II command is used to cause a label to print.

Note • You do not need to open a telnet session if you pinged the printer using the previous procedure. The purpose of these two procedures is to identify whether your PC can communicate with your printer.

To open a telnet session on your PC, complete these steps:

1.Open a DOS window.

To open a DOS window, click on Start > Run.

2.In the Open text box, type: cmd

3.From the DOS prompt, type:

telnet xxx.xxx.xxx.xxx 9100

where xxx.xxx.xxx.xxx is the IP address of the print server.

This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.

4.Enter ~WC.

This ZPL command will print a configuration label on your printer.

5.Click the X in the upper right-hand corner of the window to exit.

If the configuration label prints, the issue is not a communication problem between the printer, the print server, or the PC.

85

07/18/2008 BradyConnect 10/100 Internal Print Server User Guide Y885775