Siemens se5880 manual Access Easy Setup Wizard, Untrusted Interface Configuration, Using PPPoE

Chapter 3 Easy Setup

This chapter describes how to define router configuration settings using the Easy Setup Wizard. These settings control access to the Wide Area Network (WAN) and Local Area Network (LAN). During the Easy Setup procedure, you will be prompted to specify configuration parameters that may require information from your service provider.

Access Easy Setup Wizard

To access the Easy Setup Wizard, click Easy Setup in the left navigation pane of the Router Information window. This wizard will walk you through the configuration screens necessary to setup the router. You can exit the Easy Setup Wizard at anytime by clicking Cancel on the bottom of the configuration page. If the wizard is cancelled, no changes will be made and you will need to begin again.

Untrusted Interface Configuration

When you click Easy Setup in the left navigation pane of the Router Information page, the Untrusted Interface Configuration page is displayed. This page is used to enter information for the Untrusted (WAN-side) Ethernet Interface that will communicate with the Internet access device (for example, broadband modem or similar). Note that PPPoE IP Address and PPPoE IP Gateway are displayed only when Dial backup is enabled.

1.Select one of the following connection methods.

•Using PPPoE:

Uses the Point-to-Point Protocol (PPP) to establish the connection. Refer to Using PPPoE for instructions on providing

information on this page for this method.

•Not Using PPPoE

Establishes the connection based on IP addressing. This option routes all IP packets for remote hosts to the WAN. Refer to Not Using PPPoE for instructions on providing information on this page for this method.

SIEMENS 16