Radio Shack Okidata C6100 manual Disconnect Current Printer If one exists, Windows Network Setup

Page 6

Step 4 – Disconnect Current Printer (If one exists)

1.Press the power button to turn off the printer.

2.Disconnect the power cable from the power outlet and from the printer.

Step 5 - Connect New Printer / Load Software

For this portion, refer to the diagram provided on page 20. (Diagram – Rear View)

•Place the printer in its designated area.

•Connect the power cord to a power outlet. When possible, connect the (C6100) power cord to a dedicated power outlet.

NOTE: It is recommended that you use the power cord shipped with the printer.

Windows Network Setup

1.Turn the printer OFF.

2.Remove the plastic cap from the LAN port (1).

3.Connect the Ethernet cable between the printer and a spare port on the Ethernet hub or router.

3.Turn the Printer ON and wait for the status light (2) to stop blinking.

4.Insert the CD in the CD-ROM drive. The CD will auto-run. If it doesn't, click Start > Run > Browse. Browse to your CD-ROM drive, double-click Setup.exe. Click OK.

5.Select your language:

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Okidata C6100 Setup & User Guide Table of Contents Unpack / Prepare Printer Remove orange piece Install Handy Reference Guide Print DemoWindows Network Setup Disconnect Current Printer If one existsConnect New Printer / Load Software Click Install Driver Page Page Page Print Only in Black and White Check Toner LifeReplace a Toner Cartridge Page Page Replace an Image Drum Page Page Page Replace the Fuser Page Check Current Printer Settings Reset Factory Default Settings Service and SupportOKI Printer Supplies Diagram Front View Diagram Rear View
Top Page Image Contents