Keyspan:Mini Port Replicator for Mac
7.1.c.01 - Palm Desktop
Before you begin...
This Configuration Example assumes that you have already done the following:
1.installed the Keyspan serial port hardware and software
2.installed the Palm Desktop software
3.connected the Palm Serial Cradle hardware to a Keyspan serial port
If you have not performed any of the steps mentioned above, please do so before proceeding.
Step 1 - Check the Keyspan Serial Assistant
Before proceeding, you should check to see if the Keyspan serial port is installed correctly.
To do this, open the Keyspan Serial Assistant (located in Control Panels). When you open the Keyspan Serial Assistant, you will see a window similar to the one shown below:
the Keyspan Serial Assistant window
If your Keyspan hardware and software are installed correctly, the 'Serial Adapter Status' text box will report 'Driver and
If you see either of these messages, proceed to Step 2. If you do not receive either of these messages, proceed Problem Solving section in this manual.
This User Manual applies to the Keyspan Mini Port Replicator Software for Mac OS.
(rev 02jun20JA)
Page 26