Keyspan:Mini Port Replicator for Mac
Step 3 - Check the Keyspan Serial Assistant
Now that your serial device is connected to the Keyspan adapter, you should check to see if the Keyspan serial port is installed correctly.
To do this, open the Keyspan Serial Assistant (located in Control Panels). When you open the Keyspan Serial Assistant, you will see the following window:
the Keyspan Serial Assistant window
If your Keyspan hardware and software are installed correctly, the 'Serial Adapter Status' text box will report 'Driver and
If you see either of these messages, proceed to Step 4. If you do not receive either of these messages, proceed Problem Solving section in this manual.
Step 4 - Determine Where To Select/Configure The Keyspan Serial Port(s)
Prior to using your serial device with a Keyspan serial port, you must first tell that serial device's software which serial port your serial device hardware is connected to.
(continued on next page...)
This User Manual applies to the Keyspan Mini Port Replicator Software for Mac OS.
(rev 02jun20JA)
Page 8