Setting the TV System (European model only)
While the OSD mode is set to On, you can set the RI Dock’s video output to PAL or NTSC.
If the onscreen display looks distorted on your TV, try changing the TV system.
•While pressing and holding down the [SETUP] button, press the VOLUME Up [ 
]
button for more than 3 seconds to select NTSC, or press the VOLUME Down [ ] but- ton for more than 3 seconds to select PAL.
Other Functions
■Functions
Depending on your amp and generation of iPod/iPhone, you may also be able to use the following functions.
Note:
•Your amp may take several seconds to startup, so you might not hear the first few seconds of the first song/video.
•System On Function
When you turn on your amp, the iPod/iPhone turns on as well. With some amps, you may need to press the [ON] button on your amp’s remote controller’s twice to turn on the other components in your system.
• System Off Function
When you turn off your amp, the iPod/iPhone turns off as well.
• Auto Power On Function*
If you start iPod/iPhone playback while your amp is on Standby, your amp will automatically turn on and select your iPod/iPhone as the input source. Then, your iPod/iPhone will start playback.
• Direct Change Function*
If you start iPod/iPhone playback while listen- ing to another input source, your amp will automatically select your iPod/iPhone as the input source.
*If you use your iPod/iPhone model’s controls to start an iPod/iPhone slideshow or video, these functions will not work, so use the remote controller instead.
• Timer Play
You can use your amp’s Timer function to turn on your amp and iPod/iPhone and start play- back at a specified time.
•Using Your Amp’s Remote Controller You can use your amp’s remote controller to control basic iPod/iPhone functions (see page 14).
Operating Notes:
•The RI Dock must be connected to your amp with both an cable and an audio cable to use the functions.
•If your amp doesn’t support the System On, System Off, Auto Power On, and Direct Change functions, you’ll need to turn your amp on and off and select the input source manually.
•Before you select another input source, stop iPod/iPhone playback to prevent your amp from selecting the iPod/iPhone input source by mistake.
•If any accessories are connected to your iPod/iPhone, your amp may not be able to select the input source properly.
•While your iPod/iPhone is in the RI Dock, its volume control has no effect. If you adjust your iPod/iPhone model’s volume control while it’s in the RI Dock, make sure it’s not set too high before you reconnect your headphones.
12