Replacing the Battery, Aiming the Remote Controller

Replacing the Battery

Use only a battery of the same type (CR 2025).

1.To open the battery compartment, press the small hollow and slide open the cover.

2.While pressing the tab as shown, slide out the old battery.

Slide the new battery into the battery com- partment with the positive side facing up.

Aiming the Remote Controller

When using the remote controller, point it toward the RI Dock’s remote control sensor, as shown below.

Remote control sensor

					m
				5
				.
			x
		o			.)
		r			.)
	p				t
p				f
A			6
		1
		(

RI Dock

3.Slide the cover shut.

Notes:

•If the remote controller doesn’t work reli- ably, try replacing the battery.

•If you intend not to use the remote con- troller for a long time, remove the battery to prevent damage from leakage or cor- rosion.

•An expired battery should be removed as soon as possible to prevent damage from leakage or corrosion.

Caution: Replacing the battery incorrectly may cause an explosion. Use only a battery of the same type or an equivalent.

Notes:

•If the RI Dock is placed on top of another component, the remote controller’s sig- nal may be obstructed and the remote controller may not work reliably.

•The remote controller may not work reli- ably if the RI Dock is subjected to bright light, such as direct sunlight or inverter- type fluorescent lights. Keep this in mind when installing.

•If another remote controller of the same type is used in the same room, or the RI Dock is installed close to equipment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything on top of the remote controller, such as a book or magazine, because a button may be pressed contin- uously, thereby draining the batteries.

•The remote controller may not work reli- ably if the RI Dock is installed in a rack behind colored glass doors. Keep this in mind when installing.

•The remote controller will not work if there’s an obstacle between it and the RI Dock’s remote control sensor.