■Using Your iPod/iPhone model’s Alarm Clock
You can use your iPod/iPhone model’s Alarm Clock function to automatically turn on your iPod/iPhone and amp at a specified time. Your amp’s input source will automatically be set to the input to which your iPod/iPhone is con- nected.
Notes:
•This function only works when the OSD mode is set to Off.
•To use this function, your iPod/iPhone must be in the RI Dock, and the RI Dock must be connected to your amp with both an cable and an audio cable.
•When you use this function, be sure to set your amp’s volume control to a suitable level.
•Your amp may take several seconds to startup, so you might not hear the first few seconds of the first song/video.
■Charging Your iPod/iPhone model’s Bat- tery
The RI Dock charges your iPod/iPhone model’s battery while your iPod/iPhone is in the RI Dock.
Notes:
•To charge your iPod/iPhone battery, the AC adapter must be plugged into a suit- able wall outlet and connected to the RI Dock’s DC IN jack.
•See your iPod/iPhone model’s instruction manual for more information on battery charging.
Setting the Remote Controller’s ID
If you cannot adjust the volume of your Onkyo component with the
Some Onkyo components are set to ID #2 or #3.
•While pressing and holding down the [SETUP] button, press one of the following buttons for more than 3 seconds to set the ID:
ID #1: PLAYLIST Up [ 
] button
ID #2: ALBUM Up [ 
] button
ID #3: PLAYLIST Down [ | ] button |
ID #4: ALBUM Down [ | ] button |
13