Toshiba SPAA-207-R1, TSMB0039901, TRST-A10 SERIES Connecting the Power Cord and Interface Cable

Page 17

5. INSTALLATION PROCEDURE

SPAA-207-R1 5.1 Connecting the Power Cord and Interface Cable

5.1 Connecting the Power Cord and Interface Cable

CAUTION!

1.Be sure to hold the connector when plugging in or unplugging the AC adapter cable.

2.Insert the AC adapter cable and the power cord firmly.

1)Turn the printer power OFF.

2)Insert the power cord into the AC inlet.

3)Connect and secure the interface cable to the interface connector in the correct orientation. Serial interface: Secure the connector with the screws.

USB interface: Securely insert the connector until a positive click is heard.

Parallel interface: Secure the connector with the locking tabs.

[Serial Interface Connector]

[USB Interface Connector]

[Parallel Interface Connector]

5-2

Image 17

Contents TRST-A10 Series CE Compliance for EU only Safety Summary Request Regarding Maintenance PrecautionsTable of Contents Introduction FeaturesProduct Overview Printer SpecificationsDescription Mm PaperReceipt Roll LED and Feed Button AppearanceFront/Rear View Problem What to Do Where to Go DC24V Socket connector ConnectorsSerial interface connector USB interface connectorRequirements for Operation SET UP ProcedureRS-232C cable pin configuration Strobe Setting up the Printer Installation Procedure Connecting the Power Cord and Interface Cable Installation Procedure Ground terminal 6-pin modular connector Connecting the DrawerDrawer interface connector 6-pin modular connector Loading the Receipt Roll Edge Exit Self Test PrintRolling Ascii print test Receipt Print test Receipt Duty check print test Receipt 00000008Print current setting Current Setting FormCleaning General MaintenanceRemoving Jammed Paper Solution TroubleshootingProblem Check Point Waste Recycling information for users