7. Troubleshooting
7. TROUBLESHOOTING
WARNING!
If you cannot solve a problem with the following solutions, do not attempt to repair it by yourself. Turn the power off, unplug the printer, then contact your authorized TOSHIBA TEC representative for assistance.
Problem |
|
| Check Point |
| Solution |
|
|
| |||
The power is not turned | • | Is the power cord plugged | • | Plug it in correctly. | |
on. (Power LED does |
| in correctly? |
|
| |
not light.) | • | Is power supplied to the | • | If it is not a power failure, | |
|
|
| AC outlet? |
| check if the power is supplied |
|
|
|
|
| to the AC outlet with another |
|
|
|
|
| electric appliance. If not, |
|
|
|
|
| contact your nearest power |
|
|
|
|
| company. |
|
| • | Has the circuit breaker | • | Check the circuit breaker. |
|
|
| tripped? |
|
|
|
|
|
|
| |
Receipt paper is not | • | Is the receipt roll loaded | • | Refer to Section 5.3 and load | |
issued. |
| properly? |
| the receipt roll properly. | |
|
| • | Does a paper jam error | • | Refer to Section 6.2 and |
|
|
| occur? |
| remove the jammed paper, |
|
|
|
|
| and |
|
|
|
|
| |
No printing is performed | • | Is the interface cable | • | Connect the interface cable | |
though the POWER LED |
| connected correctly? |
| correctly. | |
lights. | • | Does the specification of | • | Use a TOSHIBA TEC- | |
|
|
| the interface cable meet |
| recommended interface cable |
|
|
| that of the POS terminal |
| or an interface cable which |
|
|
| or the printer? |
| meets the specification of the |
|
|
|
|
| printer. |
|
|
|
|
| |
Issued receipt paper is | • | Is the print head dirty? | • | Refer to Section 6.1 and | |
stained. |
|
|
| clean the print head. | |
|
|
|
|
| |
Irregular print/blurred | • | Is the proper paper used? | • | Refer to Section 2.3 and use | |
|
|
| the TOSHIBA TEC specified | ||
|
| • Is the paper dampened? | • | paper. | |
|
|
|
| Do not use dampened paper | |
NOTE: If any problem occurs other than the above, please contact your authorized TOSHIBA TEC representative.