Toshiba TRST-A00 Important Information to the User, Power Supply, Interface Cable, Power Cord

Page 5

EO1-13027

1.1 Introduction

Important Information to the User

In order to meet Product Safety, FCC and CE marking requirements, it is advised to use the power supply, power cord, and interface cable which were shipped with this product. Otherwise these devices need to meet following standards:

Power Supply

The power supply should follow UL/EN/IEC60950 certification, Class 1 power supply with SELV (Secondary Extra Low Voltage), non-energy hazard output, limited power source, input rated 100-240 Vac, 1.5/0.8 A, 50/60 Hz, output rated 24 Vdc, 3.15A.If this product is used with a power supply different from the Toshiba TEC power supply, you will need to test this power supply and the Toshiba TEC printer to comply to FCC and CE mark certification.

Interface Cable

You are advised to use a shielded (360 degree) interface cable with this product. The shield must be connected to the frame or earth ground connection or earth ground reference at BOTH ends of the cable.

If another cable is used than described above you will need to test this cable with the Toshiba TEC printer and your system for FCC and CE mark certification.

Power Cord

For this product a UL listed, detachable power cord is required. When the power supply is mounted on the floor, a power cord with Type SJT marking is required. Outside the US, power cords need to meet the particular country’s certification and application requirements. If a power cord is used different from described above you might violate safety certifications which are in force in the country of use.

The socket-outlet needs to be installed near the equipment and must be easily accessible.

(iii)

Image 5
Contents TRST-A00 Series CE Compliance for EU only Safety Summary Request Regarding Maintenance PrecautionsPower Cord Power SupplyImportant Information to the User Interface CableNetzgerät Wichtige BenutzerinformationenVerbindungskabel NetzanschlußkabelTable of Contents Introduction FeaturesProduct Overview TRST-A Applicable ModelModel name description Printer SeriesAccessory Mm Paper SpecificationsPrinter Model Description OptionsReceipt Roll Front/Rear View AppearanceLED and Feed Button Rear ViewProblem What to Do Where to Go Error Status TableRS-232C I/F model USB I/F model DC24V Socket connector ConnectorsSerial interface connector USB interface connectorRequirements for Operation SET UP ProcedureSerial Interface Type Interface CablesRS-232C cable pin configuration Setting up the Printer Installation Procedure Connecting the Power Cord and Interface Cable Installation Procedure Ground terminal 6-pin modular connector Connecting the DrawerDrawer interface connector 6-pin modular connector Loading the Receipt Roll Edge Exit Self Test PrintRolling Ascii print test Receipt Print test Receipt Duty check print test Receipt Current Setting Form Print current settingCleaning General MaintenanceRemoving Jammed Paper Check Point TroubleshootingWaste Recycling information for users EO1-13027